726821
21
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
Selecting the installation location
The unit is designed for horizontal
installation on a base in outdoor
areas. The installation site must be
level, flat and firm. The unit should
also be secured to prevent it from
tipping over.
For external installation, please
observe the following instructions
to protect the unit from
the influence of the weather.
It is also possible to install
the unit in the interior of
the building. However, in this case
the circulation of the required air
flow volume (see technical data)
must be assured. Any change
to the air flow volume can result
in faults or damage to the unit.
Rain
The unit should be at least 10 cm
off the ground when mounted on
the roof or ground.
Sun
The finned condenser gives
off heat in cooling mode.
Exposure to sunlight further
increases the temperature of
the fins and reduces the heat
released by the finned heat
exchanger.
The unit should, whenever
possible, be installed on the north
side of the building.
If necessary, take measures
to provide sufficient shade
(responsibility of customer).
This could be a small roof.
However, the discharging warm
air flow must not be affected by
the measures.
Wind
If the unit is being installed
inwindy areas, ensure that
the warm outlet air is discharged
in the prevailing wind direction.
If this is not possible, it may be
necessary to install a windbreak
on-site (Figure 3).
Ensure that the windbreak does
not adversely affect the air intake
to the unit.
20 cm
Snow
2 Minimum clearance to snow
Snow
The unit should be wall-mounted
in areas of heavy snowfall.
Installation should be at least
20 cm above the expected
level of snow to prevent snow
from entering the outdoor unit
(Figure 2).
Wind
3 Windbreak
Warm air
Cold
fresh air
Light well
Chiller
Warm air
Light well
Additional
fan
4 Installation inside buildings (cooling mode)
Sun
The finned condenser gives off
heat in cooling mode.
Exposure to sunlight further
increases the temperature
of the fins and reduces the heat
released by the finned heat
exchanger.
Cooling capacity changes as
a consequence of ambient
conditions inuenced by rain, sun,
wind, and snow, for example.
NOTE
21
21

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw REMKO RVS DC serie 50-80-130-180 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van REMKO RVS DC serie 50-80-130-180 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,08 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van REMKO RVS DC serie 50-80-130-180

REMKO RVS DC serie 50-80-130-180 Gebruiksaanwijzing - Deutsch - 44 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info