726600
16
Verklein
Vergroot
Pagina terug
1/68
Pagina verder
3 Design and function
3.1 Unit description
In cooling mode, the MVV outdoor unit (OU) serves
to output the heat extracted by the indoor unit (IU)
from the room being cooled. In heating mode, the
heat taken up by the outdoor unit can be dis-
charged by the indoor unit into the room to be
heated. In both operating modes, the output pro-
duced by the compressor precisely matches
requirements, and thereby regulates the nominal
temperature with minimal temperature deviations.
This "inverter technology" results in energy savings
over conventional split systems and also reduces
noise emissions to a particularly low level. The out-
door unit can be installed in an outdoor area or
,
providing that certain requirements are met, an
indoor area. The indoor units are designed to be
mounted high up on the wall, in an indoor area
(MVW) or for installation in suspended ceilings
(MVD) and are equipped with an electronic flow
regulator. The outdoor unit can be combined with
REMKO indoor units from the series MVW and
MVD that provide sufficient cooling capacity (see
Ä
Chapter 2.1 ‘Unit data’ on page 8). No more
than 130% of the nominal cooling output of the
indoor unit output may be installed. Operation
takes place as standard via an infra-red remote
control. The outdoor unit consists of a cycle with a
compressor, fin condenser, electronic expansion
valve and a condenser fan. The outdoor unit
cooling cycle is controlled by the controller of the
indoor unit. In order to enable operation of the unit
at low outside temperatures, a thermal
condenser pressure regulator serves as winter fan
speed control to regulate the speed of the con-
denser fan.
Refrigerant piping and distributors are used to
establish the connection between the indoor unit
and the outdoor unit.
System layout
The indoor units of unit series MVW / MVD must
always be connected to a Y-distributor or a 4-fold
distributor.
A maximum of 4Y distributors may be used per
outdoor unit and liquid or suction pipe.
With the installation of more than one indoor unit
per level, a 4-fold distributor must be used in order
to distribute the refrigerant.
Exception: Installation of 2 indoor units at the end
of the main line.
5
6
4
3
2
4
B
A
1a
7b
3
7a
8b8a
9b9a
10
1b
3
10
Fig. 7: System layout
A: Outdoor area
B: Indoor area
1 a,b: Indoor units
2: Outdoor unit
3: Condensate drainage line
4: Condenser fan
5: Outdoor unit power supply
6: Shut-off valve
7 a,b: Suction pipes
8 a,b: Liquid pipes
9 a,b: Control lines
10: Power supply to indoor units
REMKO MVV...DC
16
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw REMKO MVV 2000 DC Duo bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van REMKO MVV 2000 DC Duo in de taal/talen: Engels als bijlage per email.

De handleiding is 3,87 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van REMKO MVV 2000 DC Duo

REMKO MVV 2000 DC Duo Gebruiksaanwijzing - Deutsch - 68 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info