587706
13
Verklein
Vergroot
Pagina terug
1/28
Pagina verder
Control line
Condensation line
Injection pipe
Suction pipe
PVC tube
1
Pipes and cables in wall breakthrough
Selection of the installation
location
The outdoor unit is designed for
horizontal free-standing use in
outdoor areas.
It should be placed on level,
flat and firm ground. The unit
should also be secured to prevent
toppling.
The outdoor unit can be installed
both inside and outside buildings.
In the case of outdoor installation,
please follow the instructions given
below to protect the unit against
the weather.
Rain
The unit should be at least 10 cm
off the ground when mounted on
the roof or ground.
An optional floor bracket is
available as an accessory.
Sun
The liquefier on the outdoor unit
radiates heat.
Exposure to direct sunlight will
further increase the temperature
of the fins and reduce the heat
output of the liquefier.
The outdoor unit should therefore
be installed as near as possible to
the north side of the building.
If necessary, take measures
to provide sufficient shade
(responsibility of customer). One
possible solution is to build a small
roof.
However, the discharging warm air
flow may not be affected by the
measures.
Wind
If the unit is being installed
in windy areas, ensure the air
discharges in the prevailing wind
direction. If this is not the case
it may be necessary to install
a windbreak (provided by the
customer) (Figure 2).
Ensure that the windbreak does
not adversely affect the air intake
to the unit.
Wind
2 Windbreak
20 cm
Snow
3 Minimum clearance to snow
Snow
The unit should be wall-mounted
in areas of heavy snowfall.
Installation should then be min.
20 cm above the expected level
of snow to prevent snow from
entering the outdoor unit (Fig 3).
An optional wall bracket is
available as an accessory.
Installation inside buildings
Ensure there is adequate heat
dissipation when placing the
outdoor unit in cellars, attics,
adjoining rooms or halls
(Figure 4).
Install an additional fan with
a rated flow comparative to
that of the outdoor unit being
installed in the room. This
is used in conjunction with
ventilation ducts to compensate
any pressure losses
(Figure 4).
Ensure a continuous and
unobstructed air flow from
outside, preferably using
sufficiently large air inlets
(Figure 4).
Comply with any regulations
and conditions affecting
the statics of the building.
If necessary, fit acoustic
installation.
Warm air
Cold
Fresh air
Light
well
Outdoor unit
Warm air
Light
well
Additional
fan
4 Installation inside buildings
13
13

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw REMKO MVT900 DC bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van REMKO MVT900 DC in de taal/talen: Engels als bijlage per email.

De handleiding is 1,43 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van REMKO MVT900 DC

REMKO MVT900 DC Gebruiksaanwijzing - Nederlands - 28 pagina's

REMKO MVT900 DC Gebruiksaanwijzing - Deutsch - 24 pagina's

REMKO MVT900 DC Gebruiksaanwijzing - Deutsch - 28 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info