Controlling the Walk Assist
Use the Walk Assist feature to easily take the bicycle
by the hand, for example when taking it out of
underground storage. Stand rmly next to the bike and
hold your hands on the handlebars. If a brake lever is
present, keep at least one hand on the brake where
the brake-circuit breaker (interrupon of the motor
assistance) is located. This is generally is the le brake
lever. Keep the ‘PLUS’ buon pressed while rmly
holding the handlebars. The engine will start aer a few
seconds. Once you release the ‘PLUS’ buon the Walk
Assist funcon switches itself o. The Walk Assist has a
speed of 6 km/h (no load).
Bicycle lights
Press the ‘ON/OFF’ buon to turn on the bicycle lights.
Press ‘ON/OFF’ again to turn it o again.
USB connecon
The USB connecon on the back of the display can be
used to provide power to devices such as smartphones
and navigaon devices. It can also be used when the
system is o, if the baery is sll on the bike.
Reseng the Trip data
By pressing and holding the ‘MINUS’ buon for two
seconds you can reset the trip distance. This also
resets the logged maximum speed and mer. If the trip
distance reaches the 500 km it will be automacally
reset.
Sengs menu
By pressing and holding the ‘SET’ buon for 2 seconds
you can open the sengs menu. By pressing ‘SET’
shortly you can switch between the dierent sengs,
with the ‘PLUS’ and ‘MINUS’ buons you can changes
the values. Leave the sengs menu by holding ‘SET’
buon.
SET 1: Seng the Driving-mode
Please note: Opon only availible on P-MN7 / P-MN360
With the ‘PLUS’ and ‘MINUS’ buons you can adjust the
driving-mode. Not every cyclist is the same. One likes a
powerful support where someone else prefers an extra
high range. Therefore the display has 3 dierent driving
modes that inuence the motorpower:
ECO: Extra high range, less motorpower
NORMAL: Average range, average motorpower
POWER: Extra motorpower, lower range
