815530
12
Verklein
Vergroot
Pagina terug
1/30
Pagina verder
12 10/238106-804K
The appliance will go into the ignition sequence followed
by start up (The green LED will ash rapidly). The ignition
sequence involves the exhaust blower turning on, the igniter
turning on, and the feed motor running in two stages. The
rststageinvolvesthe feed motorrunningcontinuouslyfor
aboutaminutetopreloadpelletsintotherepot.Following
the preload and a delay, the feed motor will begin cycling on
ando󰀨.Whenthepelletsarewarmingupandonthevergeof
igniting,itisnotuncommonforthereboxtollwithsmoke.
Onceignitionactuallyhappens,thesmokeshouldevacuate
quickly. During this stage as well as any part during the burn
process, the front door should not be opened. This cycle
continues until the appliance senses ignition by a rise in the
exhaust temperature or the appliance times out. Following
the ignition cycle the appliance begins to feed additional
pelletsgraduallyforafewminutestobuildupthere.Thisis
important to have a controlled start up to keep the appliance
in balance.
F. Fire Characteristics
The overall height of the ame will vary throughout the
burnforacoupleofreasons.Theamewillvarybasedon
type of fuel or even batch of fuel. The second characteristic
that a󰀨ects the re relates to general maintenance and
cleaning.Infrequentorpoorgeneralmaintenancewillresult
ispoorerperformance.Indicatorsoftheneedforadditional
maintenance activities include a lazy ame, black sooted
glass, pellets not igniting, or pellets falling to the side of
the repot. See the maintenance section for additional
information.
G. Ignition Cycles
1. At the beginning of each ignition cycle, it is normal to see
somesmokeintherebox.Thesmokewillstoponcethe
restarts.
2. The convection blower will automatically turn on after
your appliance has reachedasu󰀩cienttemperature.
3. This blower transfers heat from your appliance into the
room, and will continue to run even after the appliance
hasshutdown.Itwillturno󰀨aftertheexhausttemperature
has cooled.
4. Occasionallytheappliance may run out of fuel and shut
itself down. When this happens the empty hopper alarm
will be triggered.
H. Trim Adjustment
Trim adjustment is the small dial located below the main
dial control. The function of the trim adjustment is to allow for
variationsinelevation,ventingandinstallationcongurations,
and fuel types (hard wood/soft wood).
Odors, vapors, and smoke released during
initial operation.
Curing of high temperature paint.
Openwindowsforaircirculation.
Odorsmaybeirritatingtosensitiveindividuals.
CAUTION
!
Figure 12.1
I. Clear Space
NOTICE: Clearances may only be reduced by means
approved by the regulatory authority having jurisdiction.
Mantel: Avoid placing candles and other heat-sensitive
objects on mantel or hearth. Heat may damage these objects.
RISK OF FIRE!
DoNOTplacecombustibleobjectsinfrontortothesides
of the appliance. High temperatures may ignite clothing,
furniture or draperies.
WARNING
!
RISK OF FIRE!
Keep combustible materials, gasoline and other
ammablevaporsandliquidsclearofappliance.
Do NOT store ammable materials in the
appliance’s vicinity.
DoNOTusegasoline,lanternfuel,kerosene,charcoal
lighteruidorsimilarliquidstostartor“freshenup”a
reinthisheater.
Keep all such liquids well away from the heater while it is
in use as combustible materials may ignite.
WARNING
!
Rotatingthisdialwilladjusttheair/fuelratiototheappliance:
• Clockwiseadjustmentsincreasetheameheight.
• Counter-clockwise adjustments will decrease the ame
height.
When changing trim settings only adjust 1 level at a time,
allowing 15 minutes for re to stabilize before making
another adjustment. It may be necessary for an event to
happenbeforeanadjustmenttakese󰀨ect.Toensurethe
trim adjustment takes e󰀨ect, change the dial control to a
di󰀨erentburnrate.Afterthestovehasadjustedtothenew
burn rate, rotate the dial back to the desired setting.
The factory default trim adjustments are set to zero (0) for
mostfuelsandrecommendedventingcongurations.
Aproperlyadjustedrewillhaveabright,activeamepattern
that extends out of the re pot approximately 6 to 9 inches
whenburningonhigh.Aproperlyadjustedrewillburncleaner
andhavehighere󰀩ciencies.
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Quadra-Fire Outfitter I - Pellet bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Quadra-Fire Outfitter I - Pellet in de taal/talen: Engels als bijlage per email.

De handleiding is 4.15 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Quadra-Fire Outfitter I - Pellet

Quadra-Fire Outfitter I - Pellet Gebruiksaanwijzing - Français - 30 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info