815524
10
Verklein
Vergroot
Pagina terug
1/40
Pagina verder
10 7027-802M 04/23
Figure 10.1
G. General Operating Information
1. Thermostat Calls For Heat
The appliance is like most modern furnaces; when the
thermostat calls for heat, your appliance will automatically
light and deliver heat. When the room is up to temperature
and the thermostat is satised, the red call light will go o󰀨
and the appliance will shut down (Figure 10.1).
2. Heat Output Controls
This appliance is equipped with a heat output control
switch that has three settings or burn rates; low, medium
and high. The appliance will turn on and o󰀨 as the
thermostat demands. When the thermostat calls for heat,
the appliance will start up on the high setting for the rst
4 minutes and 15 seconds, then automatically switch to
the burn rate for which it is set. If the appliance is set
at one of the lower settings, it will run quieter but take
longer to heat up an area than if it were set at a higher
burn rate. Regardless of the burn rate, when the area
is warm enough to satisfy the thermostat, the appliance
will shut o󰀨.
3. Fan Speed Switch
This switch will adjust the speed of the room distribution
air fan or convection blower on all three settings. This
means you have six di󰀨erent blower speeds available as
there is a high and low on each setting.
5. For your rst re it will be necessary to press the reset
button every two minutes until pellets start to drop into
the re pot, then press button 1 more time. This will ll the
feed system and allow the appliance to begin dropping
pellets. The appliance will continue to run as long as the
thermostat is calling for heat.
6. Once the appliance has ignited, let it burn for
approximately 15 minutes, then set the thermostat to the
desired room temperature. Adjust the heat output control
switch to the desired setting.
I. Fire Characteristics
A properly adjusted re with the heat output control switch
set on “high” has a short active ame pattern that extends
out of the re pot approximately 4 to 6 inches (102 to
152mm). If the re has tall ames with black tails and seems
somewhat lazy, the feed rate will need to be reduced. This
is done by sliding the fuel adjustment control rod down,
which will reduce the feed. If the re is not 4 to 6 inches
(102 to 152mm) tall, slide the fuel adjustment control rod up
to increase the feed. A medium and low setting will give a
shorter ame. The ame will rise and fall somewhat. This
is normal.
Fire Risk
Do NOT operate appliance:
With appliance door open.
Fire pot oor open.
Cleaning slide plates open.
WARNING
Do NOT store fuel:
Closer than required clearances to combustibles to
appliance
Within space required for loading or ash removal.
H. Starting Your First Fire
1. A thermostat is required for proper operation of this
appliance. At this time, ll the hopper with pellets, set the
thermostat to its lowest setting. Plug the power cord into
nearby outlet.
2. The exhaust blower will stay on for approximately 10
minutes even though the thermostat is not calling for
heat. This is normal.
3. Locate the heat output control switch mounted on the
right side. Switch it to the high setting by pushing the top
of the switch in, then adjust the thermostat to its highest
setting. The red call light located on the upper right
corner of the right side panel will be on. This indicates
the thermostat is calling for heat (Figure 10.1).
4. The fuel feed system and the igniter should now be on.
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Quadra-Fire Classic Bay 1200 Pellet bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Quadra-Fire Classic Bay 1200 Pellet in de taal/talen: Engels als bijlage per email.

De handleiding is 5.89 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Quadra-Fire Classic Bay 1200 Pellet

Quadra-Fire Classic Bay 1200 Pellet Gebruiksaanwijzing - Français - 40 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info