MEMORIES
The TX-240 has an internal phonebook-memory for 80 telephonen-
umbers with name. This memory is linked to the Caller-ID; if the
Caller-ID receives a call with a number, which is stored in this
memory, the display will show the matching name.
PROGRAMMING:
1. Leave the handset on the cradle
2. Press and hold button
3. press , the display shows "ADD >>", now release the
buttons
4. press , the text "ADD >>" disappears and on the right side
on the display a cursor flashes
5. input the number:
- use and to increase or decrease the figure
- use to go to the next figure
- use to go to the previous figure
- you can also select PAUSE, FLASH, and #; because
however during an incoming call, the received number is
compared with the stored number, we recommend to not use
these figures
- a number may be as long as 13 figures, including a dail-
pause
6. as soon as the number is programmed, press button and
keep it pressed until the cursor starts to flash in the lower left
corner
7. input the name:
- use button and to input the name
- use and to select the required character
- use to go to the next character
- use to go to the previous character
- you can use all the characters of the alphabet (capitals only),
the figures 0 - 9 and several special characters
- a name can be as long as 16 characters
8. as soon as the name is programmed, press and hold until
the name and number disappears and the cursor starts to
flash on the right side of the display
9. go to step 5 for a new entry or press to end the procedure
DIALING:
1. leave the handset on the cradle
2. press and hold button
3. press , the display shows "ADD >>", you may now release
these buttons
4. press ,the display shows "REVIEW >>", press
5. use and to look for the name / number to be dialed
6. lift the handset and press to dial the selected number
28
