1. With the help of a second person, carefully raise the
Uprights (82) until the treadmill is in the position shown.
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver , wire cutters and rubber mallet .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
2. Remove the Lock Knob (110) from the Lock Pin (114).
Make sure that the Lock Pin Collar (112) and the Spring
(111) are on the Lock Pin as shown. Insert the Lock Pin
into the Latch Bracket (77).
Tighten the Lock Knob (110) onto the Lock Pin (114).
112
111
114
77
110
2
82
1
3. Refer to drawing 3a. Press a Handrail Insert (102) into
the lower end of each Handrail (85). Attach an Extension
Leg (103) to the lower end of each Handrail (85) by
loosely threading (3 or 4 turns) a Handrail Bolt (78) with
a Handrail Washer (36) into each Extension Leg and
Handrail as shown. Notice the angle of the Handrail Bolt
in the drawings at the right; attach the Bolt and Washer
at the observed angle. It should be the same as the
angle of the Handrail (see drawing 3b).
103
102
85
36
78
85
3a
78
36
103
3b
6
