5
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (A) from the Console Back (B).
Remove the Console Back from the Console Base (C).
3. Connect the included Long Jumper Wire (E) to the
PULSE jack on the back of the Console (F). If there is a
wire already plugged into the PULSE jack, unplug it.
Feed the Long Jumper Wire into the hole in the side of
the Console Base (C).
4. Connect the Long Jumper Wire (E) to the wire on the
Receiver (G). Next, peel the paper off the pad on the
back of the Receiver. Turn the Receiver so the cylinder
is on the side shown, and press the Receiver onto the
back of the Console Base (C) in the indicated location.
Note: The other wires included with the receiver may be
discarded. The Wire Tie can be used to tie wires, if
needed.
Make sure that no wires are pinched. See steps 3, 2,
and 1. Reattach the Console (F) and the Console Back
(B).
2. Have a second person hold the Console Base (C) as you
remove the indicated Screws (D) from the Console Base.
B
C
A
1
C
2
C
3
PULSE Jack
E
F
C
Cylinder
4
E
G
D
Hole
