3. Hold one of the Handrails (1) at an angle as shown and
fully insert the upper end into the right Upright (11). Keep
the lower end of the Handrail away from the treadmill to
avoid scratching the finish. Next, rotate the lower end of
the Handrail to the position shown by the dotted line.
Note: It may be necessary to pull back on the Handrail
near the arrow shown in order to position the Handrail
against the bracket on the Extension Leg (34).
3a.Refer to drawing 3a. Make sure that the hole in the
bracket on the Extension Leg (34) is aligned with the hole
in the Handrail (1). If the holes are not aligned, rotate the
Handrail away from the treadmill and slide the upper end
of the Handrail slightly out of the Upright (11) (see draw-
ing 3). Then, rotate the lower end of the Handrail back to
the position shown by the dotted line. Repeat, if neces-
sary, until the holes are aligned. Make sure that the lower
end of the Handrail (see drawing 3a) is against the
bracket on the Extension Leg. Tighten an Extension Leg
Screw (53) into the bracket and the Handrail.
Attach the other Handrail (not shown) as described above.
4. Attach the Storage Latch (14) to the left Upright (11) with
two Latch Screws (35). Be careful not to overtighten
the Latch Screws.
11
34
53
34
1
Bracket
1
Bracket
3
3a
35
14
11
4
88
5
5. Remove the backing from the Adhesive Clip (89). Press
the Adhesive Clip onto the right Upright (11) in the indi-
cated location. Press the Allen Wrench (88) into the
Adhesive Clip.
11
89
6. Make sure that all parts are tightened before you use
the treadmill. To protect the floor or carpet, place a mat
under the treadmill.
6
