6
* to maximize the bond strength of the adhesive, it is recommended to applicate the
tape under the following conditions:
• All surfaces must be clean, dry, dust and grease free.
• The adherents temperature should be between 21 and 38 degrees Celsius. Don´t
applicate below 10 degrees or under direct sunlight.
• If possible, choose a mounting position where no direct sunlight can heat up the
dashboard stand.
B. Visor and Headrest Mount
1. Use the supplied two straps and pull them through the recesses at the back of the
monitor unit.
2. Position the monitor on the visor or headrest.
3. Pull the straps across the visor or headrest.
4. Fasten the straps.
Monitor 12/24V connection
1. Route the supplied power cable to the vehicle’s cigarette
lighter socket/12V power outlet. The cable routing must not
interfere with the safe operation of the vehicle.
2. Insert the small DC plug of the power cable into the side of the
monitor.
3. Plug in the 12/24 Volt cigarette lighter plug into the vehicle’s
cigarette lighter socket.
Testing the System
1. Check if the vehicle’s negative battery cable (ground) has been reattached.
2. Turn the ignition key to the accessory position - do not start the vehicle.
3. Engage the parking brake, and put the vehicle´s shifter in the reverse position. The
System should activate itself. If not, press the Power-button on the Monitor.
4. If not already done: Please pair your camera(s) to the monitor (as described in
chapter OPERATION)
5. After testing (and re-adjusting if needed) the unit, all cabling should be installed
permanently: Route all wires behind interior panels or under carpeting. Use the
supplied cable ties to keep excess wires neat and compact.
NOTE: UNDER EXTREME BRIGHT LIGHT CONDITIONS, THE SCREEN IMAGE MAY
TAKE A FEW SECONDS TO STABILIZE. PLEASE WAIT UNTIL THE IMAGE HAS
STABILIZED BEFORE BACKING UP.
