13
Installation instructions and door reversibility for versions with Rail hinges
! It is recommended that the installation be performed by authorized technical staff
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! Cabinet dimensions are changed by material of trim ap
1
.
1. If material of trim ap
1
is plastic, look at (Table.1/B1) for cabinet dimensions.
2. If material of trim ap
1
is metal, look at (Table.1/B2) for cabinet dimensions.
! If necessary, reverse the door according to instructions.
1. See g.A for the necessary attachment components.
2. Insert trim ap
1
into slot and screw by screws
6
. (g.D)
3. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (g.B - g.C)
4. Take out the trim gasket
4
located on the side panel of the appliance and stick it on
reverse side of the door hinges of the appliance. (g.D - g.E)
5. Raise the appliance and slide into the kitchen unit.
6. Push the appliance to the reverse side of the door hinges providing that the trim gasket
2
covers the space between the appliance and the kitchen unit.
7. Align the front feet with front surface of the kitchen unit. (g.F)
8. Screw the front feet by using screws
5
. (g.F)
9. Screw trim ap
1
to kitchen unit using screws
5
. (g.G)
10. Screw guides
3
to appliance door with screws
6
. (g.H)
11. Lean appliance door to unit door as it is opened at right angle.
12. Slide rails4 into guides
3
aligning the groove. (g.H)
13. Screw the rails
4
to the unit door with screws
5
. (g.H)
14. Set 1~2 mm gap on handle side between unit itself and unit door by adjusting guides
3
.
That is vital for appliance performance. (g.H)
