6
B. Indoors:
Connect the AC power cord to the AC socket of the fridge and plug it into the power outlet. Then set the
selection switch (11) to the AC setting. Please check before use that the voltage in your home is the same
as that of the appliance (230V). Select the function by turning the selection switch (10) to the ‘cold’ or
‘hot’ position. After using the fridge, turn off the fridge by switching both selection switches to “OFF”.
CLEANING AND MAINTENANCE
Turn off the power before you clean the fridge. The appliance can be cleaned easily. The inside of the
appliance can be cleaned with a damp cloth. Be sure that you keep the chill compartment and interior of
the fridge dry. The outside of the appliance can be kept clean by polishing with a soft towel with neutral
cleanser. Be careful not to use solvents!
PRINCESS TIPS
- Never immerse the PRINCESS SILVER FRIDGE or power cords in water.
- The fridge only uses DC 12V in the car.
- Do not insert any objects into the evaporation or ventilation holes.
- Do not expose the fridge to direct sunlight.
- Keep the fridge away from sources of heat.
- Avoid spillage in the fridge.
- Unplug the appliance when it is not in use.
- Place the appliance on a stable and even surface.
- Do not use the appliance if it is damaged, or when the power supply cord is damaged, but return it to
the store to be repaired. A damaged cord can only be repaired by the Princess repair service.
- Do not connect the fridge to a 24-Volt battery, or to a power transformer. If using a DC power supply,
this has to be suitable for 4 Amps and the voltage needs to be stabilised at 12 to 14 Volts.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.
WARNING: ON NO ACCOUNT SHOULD EITHER THE LIVE OR NEUTRAL WIRES BE
CONNECTED TO THE EARTH TERMINAL
