After use (II)
1 Pull the plug out of the socket and let the TABLE CHEF™ Classic Grill cool down.
2 Clean the TABLE CHEF™ Classic Grill with kitchen paper when it has cooled down.
3 Clean the outside of the appliance with a damp cloth.
4 Dry the electrical connection well.
5 Store the TABLE CHEF™ Classic Grill in its box and keep the user’s instructions.
6 Store the TABLE CHEF™ Classic Grill in a dry and childproof place.
Note: Never pour cold water onto the hotplate. This will damage the
hotplate and cause spitting as the water heats up very quickly!
Note: Do not move the Princess TABLE CHEF™ Classic Grill while it
is in use!
Note: Do not use abrasive or strong detergents!
Tip: the hotplate may be washed up or put in the dishwasher in order to
clean it thoroughly. Do not do this with the power cord, plug or thermostat
attached. After washing allow the electrical connection to dry thoroughly.
Tip: residues which are difficult to clean off can be loosened by soaking
in a little cooking oil for about 5 minutes.
PRINCESS TIPS
- Use this baking surface only for household use.
- Make sure that the cord, or extension cord, is out of the way, so that no one can trip
over it and it doesn't touch the hot baking surface.
- If the appliance or the lead is damaged, you must stop using the appliance and bring
it back to the shop for repair. A damaged lead can only be replaced by the service
department in order to avoid a hazard.
- Keep an eye on the appliance when children are present; the baking surface gets
very hot. You should of course be careful yourself too. Let the appliance cool off
before you clear it away.
- Plug the baking surface into earthed sockets only.
- Outside use is only recommended in dry weather. Immediately pull theplug when it
starts raining. Use an earthed extension cord with a sufficient diameter (min. 3 square
mm), and unroll it completely, so that it doesn't get too hot. Make sure that the
extension cord can't touch the hot surface.
- Use only the lead supplied. Do not use a different type of lead.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE = neutral, BROWN = LIVE, GREEN-YELLOW = EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the
colour markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with
the letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN-YELLOW must be connected to the earth terminal
which is marked with the letter E or or coloured green and yellow.
With this appliance, if a 13 amp plug is used a 13 amp fuse should be fitted. If any other
type of plug is used a 15 amp fuse must be fitted either in the plug or at the distribution board.
4
