IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.
BEFORE USE
You must inspect the appliance including its cable and plug
for any signs of damage. If the product is damaged, DO NOT
use it, and contact your supplier immediately.
INSTALLATION
The EH1464 must be permanently fixed to a wall.
Draw a horizontal line on the wall and mark the centre point.
Drill two holes 285mm (11¼") either side of the centre and
insert wall plugs.
Drill a third hole 10mm above the centre point, and insert a
wall plug.
Insert screws into the outer two wall plugs and screw in until
there is a gap of about 3mm between the screw head and the
wall.
Place the heater so that the holes in the rear panel go over
the screw heads, then move it 15mm to the right so that it
hangs securely from the screws.
Insert a screw through the metal bracket on the upper part of
the case of the heater into the third wall plug and fix the
heater securely to the wall.
Page 2
