Page 9
FAULT-FINDING
If the EH1419 is not operating, proceed as follows:
Check that the mains plug is firmly in the socket, and that the
socket is switched ON.
When the unit if switched on there will be a delay of about 1
minute before it starts to operate.
• Unit stops running:
Mains supply is disconnected or has failed
Target temperature has been reached.
Timer has been set.
Water tank is full (ALARM indicator will illuminate)
• In cooling mode, no cool air is produced:
Zone temperature is lower than set temperature
The unit is defrosting (this will take a few minutes, and
afterwards, it will resume operation)
Filter is blocked
• Cooling is poor on hot days
Too much direct sunshine is heating the room
Windows or doors are open allowing hot air into the room
A lot of people in the room (each person contributes about
75 W of heating)
Electrical equipment in the room producing heat
FAULT CODES
If any error codes appear on the display, contact your local
service agent. An explanation of all the fault codes is
attached to the rear panel of the appliance.