TRM 400 Series Assembly Guide 2
Getting Started
Thank you for choosing Precor. For proper installation, please read this guide
thoroughly and follow the assembly instructions. If you do not assemble the
treadmill according to these guidelines, you can void the Precor Limited Warranty.
Installation Requirements
CAUTION: You will need assistance to assemble this unit. DO NOT attempt assembly
by yourself.
Follow these installation requirements when assembling the unit:
Assemble the unit near the location where you plan to use it and provide
ample space around the unit.
Important: Consult your owner’s manual for proper placement of your equipment.
Make sure that the power switch is OFF and that the treadmill is not plugged
into a power source. Check the ON/OFF power switch on the front of the
treadmill. Place the switch in the O (OFF) position.
Assemble the treadmill on a solid, flat surface. A smooth, flat surface under
the treadmill helps keep it level and a level treadmill will have fewer
malfunctions.
Open the box and assemble the components in the sequence presented in this
guide. If you plan to move the unit, obtain help and use proper lifting
techniques.
Important: Grasp the rear end of the treadmill frame or either side of the base
frame. Lift the treadmill and roll it on its front wheels. Do not grasp any other plastic
part while lifting or moving the unit. The plastic parts are not reinforced and they
may break.
Obtain assistance. Ask another capable adult for assistance during the
assembly process.
Use your fingers or the appropriate tools to insert fasteners. Proper alignment
helps prevent crossthreading. Do not fully wrench tighten fasteners until
instructed to do so.
Unpacking the Equipment
The treadmill is carefully tested and inspected before shipment. The unit is
shipped in two boxes. Ask for help from one or more people to unpack and
assemble the treadmill. If any items are missing, please contact your dealer.
Do not attempt to move the equipment by yourself. Have at
least one other person help you and use proper lifting
techniques.
To unpack the equipment:
1. Carefully cut and remove all plastic straps that secure the cover on the
cardboard box.
2. Lift the cover upward and set it aside.
3. Pull the cardboard or foam spacers away from the equipment and set them
aside.
4. Cut all plastic ties securing the equipment in place.
5. Remove the base frame assembly from the container and set it on the floor
where you plan to assemble and use the equipment.
Before you begin, verify that you have received the following parts:
Console box
Base frame assembly
Left and right upright supports
Console bracket
Handrail assembly
Smaller box contains:
– Dash buckets
– Hardware kit
– Assembly Guide
– Dash bucket covers
– Stop key and clip
– Chest strap
