Assembling the Exercise Bike 23
To install the upright support and prepare the cables for
connection to the console:
1. Remove the nut and washer from one end of the F-type
coaxial coupler packed with the P80 console. Insert that
end of the coupler through the round opening in the jack
panel.
2. Place the washer back onto the coaxial coupler, followed
by the nut. Use two ⁷₁₆-inch open-end wrenches to secure
the coupler; hold the coupler in place with one wrench
while tightening the nut with the second wrench.
3. Locate the tabbed end of the modular plug coupler. Snap
this end of the coupler into the square opening in the jack
panel.
4. Slide the quick-disconnect terminal on the grounding lead
of the power cable over the grounding terminal on the
equipment frame.
5. Attach the lower ends of the following cables to the inner
side of the jack panel:
– Ethernet cable (for P80 console)
– Television cable (for P80 console)
– Power cable (for P80 console)
6. Slide the jack panel back into its bracket in the right side
cover.
7. Using a piece of tape or a plastic tie, bind together the
upper ends of all cables.
8. While your assistant holds the upright support in place
over the body assembly, thread the cables upward
through the support. When you are finished, use a piece
of tape to secure the upper connectors of the cables at
the top of the support.
