POWXG6601 EN
Copyright © 2018 VARO P a g e | 6 www.varo.com
8 ASSEMBLY
WARNING: Always check that the power supply corresponds to the voltage
on the rating name plate. Remove the power tool from the packaging. Do
not plug it into the electrical grid before assembly.
8.1 Assembly (Fig. 1)
To assemble the weed burner you need to place the aluminum tube into the housing (7) as
shown on Fig. 1. To close the housing (7) you need to tighten 4 screws.
Never touch the nozzles during or immediately after use of the device. The
nozzles are very hot.
9 OPERATION
9.1 Switching ON/OFF
First check that the cable and plug are not damaged.
▪ Connect the plug to the power supply.
▪ Press on/off- and power switch (4) to start working with the weed burner.
▪ Release on/off- and power switch (4) to shut down the weed burner. Always place the
appliance on the stand (6) after use on a level, fireproof surface until the hot components
have cooled down.
The volume of air in each setting 500 l/minute
Always use with caution! Do NOT cover the ventilation openings during use
as it causes a risk of burns!
Never touch the hot nozzle!
9.2 Application tips
▪ Check that all of the relevant safety measures have been implemented.
▪ Ensure the extension handle is firmly fixed onto the device and that the device is turned
off.
▪ Lead the electrical cable away from the burner nozzle through the cable clamps on the
extension tube and handle.
▪ Insert the plug into the socket
▪ Check to ensure the nozzle is not blocked before turning the device on.
▪ Allow the device about 60 seconds to warm up.
▪ To eliminate weeds, hold the nozzle over the weeds for about 5-10 seconds. During these
5-10 seconds the cell structure of the weed is destroyed. As a result, the weed dies within
a few days.
▪ It is not necessary to completely burn the weeds, 5-10 seconds is more than sufficient.
The effects are not visible immediately but will take a while before they can be seen. It is more
of a long-term effect. Repeated treatment of certain types of weed may be necessary.
9.3 Storage:
Make sure that the device has completely cooled down before storing.
