POWXG50300 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
▪ Leave a 25mm gap between the fuel and the top of the fuel tank.
▪ Replace the fuel filler cap and tighten securely.
▪ Wipe up any spills immediately.
8 STARTING PROCEDURE
WARNING! This machine is shipped without oil and fuel. You MUST ensure
all fluid levels are correct before operation otherwise you may cause serious
engine damage that will not be covered by the warranty.
8.1 From cold
▪ Place the machine on flat level ground before starting.
▪ Turn the ignition switch to the ‘I’ ON position.
▪ Slowly press the primer bulb (10) 5 to 10 times.
NOTE: After the 7th press, fuel should be visible in the primer bulb. If it is
not, continue to press the primer bulb until you see fuel in the bulb.
▪ Push the choke button (4) in, to set the choke to FULL CHOKE position.
NOTE: Do not squeeze the throttle trigger because the choke will pop out
automatically.
▪ Pull the recoil starter handle (14) until you feel resistance. Once you feel resistance, pull
the recoil starter handle swiftly 3 to 5 times or until you hear the engine turn over or begin
to start.
▪ Allow the engine to run for 10 seconds then squeeze the throttle to release the choke in to
the RUN position.
8.2 From warm
▪ Place the machine on flat level ground before starting.
▪ Turn the ignition switch to the ‘I’ ON position.
▪ Ensure the primer bulb has fuel inside.
▪ Pull the recoil starter handle until you feel resistance. Once you feel resistance, pull the
recoil starter handle swiftly 3 to 5 times or until the engine starts.
9 STOPPING PROCEDURE
▪ Allow the engine to idle for 20 seconds under no load.
▪ Turn the ignition switch to the ‘STOP’ position.
▪ The machine should now stop.
