POWXG50100 EN
Copyright © 2019 VARO P a g e | 4 www.varo.com
▪ Inspect the entire machine for loose parts (nuts, bolts, screws, etc.) and any damage.
Repair or replace as necessary before using the machine.
▪ DO NOT USE any attachment with this power head other than the ones recommended by
our company. Serious injury to the operator or bystanders could result as well as damage
to the machine.
▪ The guard is very important to the machine. It must be screwed up on the machine before
the initial use. These guards must always be fixed when operating the machine. Check the
guard before each use. If any damage (crack, break, etc.) on the guard, contact with your
dealer for replacing it.
▪ If use of non-conformant replacement guards, or remove or modify these guards could
result in serious injury to the operator or bystanders.
▪ Always use proper handles and shoulder strap when cutting.
▪ Do not use the unit if it is damaged or poorly adjusted. Never remove the machine’s guard.
Serious injury to the operator or bystanders could result as well as damage to the
machine.
▪ Inspect the area to be cut and remove all debris that could become entangled in the nylon
cutting head. Also remove any objects that the unit may throw during cutting.
▪ Never leave the machine unattended.
▪ Do not use this unit for any job other than those for which it is intended as described in this
manual.
▪ Do not overreach. Keep proper footing and balance at all times. Do not run the unit while
standing on a ladder or on any other unstable footing location. Appropriately use the
harness provided when operating the machine.
▪ Keep hands and feet clear of the nylon cutting head while unit is in use.
▪ Do not use this type of machine for sweeping away debris.
▪ Use nylon cutting head which is free of damage. If a stone or any other obstacle is hit,
stop the engine and check the nylon cutting head. A broken or unbalanced nylon cutting
head must never be used.
▪ When ever approaching an operator of the machine, carefully call his attention and
confirm that the operator stop the engine. Be careful not to startle or distract the operator
which can cause an unsafe situation.
▪ Never touch the nylon cutting head when ever the engine is running. If it is necessary to
replace the protector or cutting attachment, be sure to stop the engine and confirm that the
cutting device has stopped running.
▪ The engine should be turned off when the machine is moved between work areas.
▪ Pay attention to loosening and overheating of parts. If there is any abnormality of the
machine, stop operation immediately and check the machine carefully. If necessary, have
the machine serviced by an authorized dealer. Never continue to operate a machine which
may be malfunctioning.
▪ In start-up or during operation of the engine, never touch hot parts such as the muffler, the
high voltage wire or the spark plug.
▪ After the engine has stopped, the muffler is still hot. Never place the machine in any
places where there are flammable materials (dry grass, etc.), combustible gasses or
combustible liquids.
▪ Pay special attention to operation in the rain or just after the rain as the ground may be
slippery.
▪ If you slip or fall to the ground or into a hole, release the throttle lever immediately.
