POWXG3042 EN
Copyright © 2017 VARO P a g e | 13 www.varo.com
14 STORAGE
WARNING: Failure to follow these steps may cause varnish to form in the
carburettor and lead to difficult starting or permanent damage after storage.
Clean outside surface of unit.
Drain fuel from the fuel tank.
After fuel is drained, start engine.
Run engine at idle until unit stops. This will purge the carburettor of fuel.
Allow engine to cool (approx. 5 minutes).
Using a sparking plug wrench, remove the sparking plug.
Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace sparking plug.
Store unit in a cool, dry place away from any source of ignition such as an oil burner,
water heater, etc.
Put the sleeve on when not in use or in transportation.
15 REMOVING A UNIT FROM STORAGE
Remove sparking plug.
Pull starter rope briskly to clear excess oil from combustion chamber.
Clean and gap sparking plug or install a new sparking plug with proper gap.
Prepare unit for operation.
Fill fuel tank with proper fuel / oil mixture. See Fuel and Lubrication Section.
16 TROUBLE SHOOTING
Follow instructions in the User
Manual.
Have carburettor adjusted by
an Authorized Service Centre.
Clean/gap or replace plug.
Fill fuel tank with properly
mixed fuel.
Press primer bulb fully and
slowly 10 times.
Replace the fuel filter.
Move to RUN position.
Replace spark arrester screen.
Remove, clean and reinstall
filter.
Have carburettor adjusted by
an Authorized Service Centre.
Have carburettor adjusted by
an Authorized Service Centre.
Replace or clean the air filter.
Drain gas tank/add fresh fuel
mixture.