POWX180 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
▪ To do this, pull the handle towards yourself and turn the screw clockwise using the
screwdriver.
▪ Insert the securing screw (7) in the saw bench (6) again and tighten it. Ensure that the
wing nut on the securing screw (7) is below the saw bench (6).
WARNING! You must remove the plate (A) via loosening the two screws (C)
with the screwdriver when tiliting the working table up to 35 degree. If not,
the frame (B) will interfere with the working table (Fig. a-c)
Fig. a Fig. b
Fig. c
6.2 Tension the saw band
Important. If the machine is at a standstill for a lengthy period of time, the tension in the saw
band (4) must be released. It is therefore important that you check the saw band tension
before switching on the machine.
▪ First of all undo the lock nut (11) on the setting screw (12) for the top saw band roller (17)
(Fig. 8).
▪ Turn the clamping screw (13) clockwise to tension the saw band (Fig. 9).
You can find the correct tension for the saw band (14) by pressing both saw band rollers
against the saw band (14) approximately in the centre.
It should only be possible to press the saw band (14) a maximum of 1 – 2 mm (Fig. 10).
Important. If the tension is too high, the saw band (14) may tear. Danger of injury!
If the tension is too low, the saw band roller (17) may simply turn whilst the saw band (14)
remains at a standstill.
▪ Tighten the lock nut (11) for the top saw band roller (17) again (Fig. 8).
