POWX1347MC EN
Copyright © 2019 VARO P a g e | 5 www.varo.com
▪ Keep your workplace clean. Blends of materials are particularly dangerous. Dust from light
alloys can burn or explode.
▪ Wear protective gloves when changing application tools/accessories.
▪ Application tools/ accessories become hot after prolonged usage.
▪ Do not scrape wetted materials (e. g. wallpaper) or on moist surfaces. Penetration of water
into the machine increases the risk of an electric shock.
▪ Do not treat the surface to be worked with solvent-containing fluids. Materials being
warmed up by the scraping can cause toxic vapours to develop.
▪ Exercise extreme caution when handling the scraper. The accessory is very sharp; danger
of injury.
7 ASSEMBLY
WARNING: Always check that the power supply corresponds to the voltage
on the rating name plate. Remove the power tool from the packaging. Do
not plug it into the electrical grid before assembly.
7.1 Mounting sanding plate/ saw blade/ spatula (Fig. 1)
WARNING: Prior to assembly and adjustment always pull out the power
plug from the mains socket.
Take care with sharp tools such as spatulas, saw blades or cutting blades.
1 Loosen the quick release clamp (7) by pulling the quick-release lever (1) completely
open.
2 Spin the quick release lever anti-clock wise until the clamping plate is lose.
3 Put the quick-install saw blade, sanding plate or spatula toward the output spindle which
is situated between the cover clamp (9) and quick release clamp (7). Push the accessory
in and place it firmly onto the locating pins (8). Pay attention that the clamping plate is
placed well into the holder of the machine, otherwise you cannot spin the quick release
lever.
4 Fasten using the quick-release lever (1), spin it in a clockwise direction to fasten the
clamping plate and accessory.
5 Check if the quick release lever is tightened enough.
6 Pull the quick release lever down and spin it until it is right above the holder.
7 Push the quick release lever into the holder.
8 Remove the accessory in the opposite way
WARNING: This tool is equipped with quick-install accessories during
operating; do not use any unmatched accessories.
WARNING: Check the tight seating of the application tool/accessory.
Incorrect or not securely fastened application tools/accessories can come
loose during operation and pose a hazard.
7.2 Mounting/changing the sand paper
With fast hook and quick release system.
▪ Position the sand paper and press by hand.
▪ Press on the sand paper by giving it a short, firm push against the flat surface of sanding
plate (12) and switch on the power tool.
This ensures good adhesion and prevents premature wear.
