POWX07598 EN
Copyright © 2020 VARO P a g e | 9 www.varo.com
7.6 Sawing
Risk of injury! If the gap between the parallel stop and the saw blade is less
than 120 mm, the push stick must be used.
Risk of injury! Always hold the guided workpiece, not the section of
workpiece that is being cut off.
Machine damage
Check the wood to be processed carefully. Foreign objects such as nails,
screws and other similar objects may seriously damage the unit
▪ Set the required gap of the parallel stop to the saw blade
▪ Set the required angle of the cross stop.
▪ Set the saw blade cutting height.
▪ Set the required tilt angle of the saw blade.
▪ Place the workpiece up against the cross stop.
▪ Switch the circular saw bench on by pressing the green button I on the On / Off switch (1).
▪ Push the workpiece evenly towards the back and saw in a single process. Make sure that
the saw Is not overloaded.
▪ Use the red button 0 on the On / Off switch (1) to switch the unit off if you are not going to
continue working immediately.
8 CLEANING AND MAINTENANCE
8.1 Cleaning and maintenance overview
Prior to each use
Check that the gap between the saw blade
and the cleaving wedge is set to 3 to 5
mm; correct if necessary.
8.2 Cleaning the device
Risk of electric shock! Never splash with water or expose to water. Never
use detergents or solvents to clean. These may cause irreparable damage
to the unit The plastic pieces may be corroded by the chemicals.