POWX07587 EN
Copyright © 2017 VARO NV P a g e | 17 www.varo.com
9.8.7 Turning over the tool (Fig. 45)
WARNING:
▪ Make sure that the tool is switched off and unplugged before turning over.
▪ When pushing down the lever (62), be sure to place your hand/finger away from the lever-
table fitting area. Hold the middle edge of table with one hand, push the lever (62) down
with the other hand while holding the table edge firmly and pivot the table carefully to turn
it over. Keep holding it until it locks.
9.8.8 Installing the top blade guard (Fig. 46)
Push the push button (8) of the top blade guard to its side surface, place it on the notch of the
riving knife (9) with the button depressed and release the button. After releasing the push
button, make sure that the top blade guard is secured by trying to pull it out.
CAUTION:
▪ After installing the top blade guard, make sure that it works smoothly.
9.9 Setting up the tool in Mitre saw mode (Fig. 47)
WARNING: Be sure to install the lower blade guard C before using the tool
in Mitre saw mode.
To change the set up from table saw mode to Mitre saw mode, reverse the procedure of the
section titled “Setting up the tool in table saw mode”.
9.9.1 Removing the top blade guard
Push the push button (8) of the top blade guard to its side surface and then just take away the
top blade guard upward with the button depressed.
9.9.2 Turning over the tool
Refer to the same titled section in the “Setting up the tool in table saw mode”.
9.9.3 Releasing the tool head from fully lowered position
While holding the handle, pull the stopper pin in the direction of arrow A, turn it to the angle of
90° in the direction of arrow B with the stopper pin pulled and then raise the handle slowly.
9.9.4 Repositioning riving knife (Fig. 48)
The position of riving knife (Fig. 48-A) should be changed as follows.
(1) Loosen the clamping nut and hold the lower blade guard A using its lug by hand. (Fig. 48-B)
(2) While holding the lower blade guard A, pull the riving knife so that it turns and pivot it to the
position in the direction of arrow. (Fig. 48-C)
(3) With the riving knife held in that position, return the lower blade guard A to the original
position and tighten the clamping nut securely. (Fig. 48-D & E)
9.9.5 Locking the tool head in the lowest position
9.9.6 Tilting the saw table
9.9.7 Installing the lower blade guard C
Place the lower blade guard C on the table so that it fits in the slot of the table and tightening
the clamping screw firmly.
