POWX075730S EN
Copyright © 2022 VARO P a g e | 11 www.varo.com
9.12 Sawing
Make sure the saw blade doesn’t block while you are sawing. It causes
damage to and burning of the motor. If there is a blockade of the saw blade,
please loosen the switch immediately to prevent damage at the motor.
▪ Clamp the work piece firmly.
▪ Set the required horizontal mitre angle or the required vertical bevel angle.
▪ Switch on the power tool.
▪ Move the handle (14) slowly downwards. (See 9.8)
▪ Saw trough the work piece.
▪ Switch off the power tool.
▪ Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
9.13 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (4) or the saw table (5).
9.14 Mitre cut (Fig.5)
▪ When a mitre cut is required, unlock the mitre table by turning the mitre handle (1)
counterclockwise.
▪ While holding the mitre handle, lift up on the positive stop locking lever (2).
▪ Rotate the mitre table to the right or left with the mitre handle.
▪ When the table is in the desired position, as shown on the mitre scale (3), release the
positive stop locking lever and tighten the mitre handle. The table is now locked at the
desired angle. Positive stops are provided at 0°, 15°, 22.5°, 31.6° and 45°.
IMPORTANT: Always tighten the mitre tablelock handle before performing
every cutting operation.
9.15 Bevel cut (Fig. 6)
▪ When a bevel cut is required, loosen the bevel lock handle (1) by turning it counter
clockwise.
▪ Tilt the cutting head to the desired angle, as shown on the bevel scale (2).
▪ The blade can be positioned at any angle, from a 90° straight cut (0° on the scale) to a 45°
left bevel. Tighten the bevel lock handle (1) to lock the cutting head in position. Positive
stops are provided at 0° and 45°.
9.16 Compound cut (Fig. 7)
A compound cut is the combination of a mitre and a bevel cut simultaneously.
▪ Loosen the bevel lock handle (1) and position the cutting head at the desired bevel
position. Lock the bevel lock handle (1).
▪ Loosen the mitre handle (2). Lift up the positive stop locking lever (3) and position the
table at the desired angle. Release the positive stop locking lever (3) and lock the mitre
handle (2).
10 CLEANING AND MAINTENANCE
Before performing any work on the equipment, pull the power plug.
10.1 Cleaning
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
