POWX0485 EN
Copyright © 2022 VARO P a g e | 5 www.varo.com
▪ Do not leave the tool running. Operate the tool only when hand-held.
▪ Ventilate your work area adequately when you perform sanding operations.
▪ Be sure that there are no cracks or breakage on the pad before use. Cracks or breakage
may cause a personal injury.
7 OPERATING INSTRUCTIONS
Before attempting to use your sander be sure to familiarize yourself with all its operating
features and safety requirements.
Warning! The sander should always be disconnected from the power
supply when assembling parts, marking adjustments, cleaning or when the
tool is not in use. Disconnecting the tool will prevent accidental starting
that could cause serious injury.
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ..).
7.1 Sanding
▪ Hold the sander in front and away from you, keeping it clear of the work piece.
▪ Start the sander
▪ Let the motor build up to speed then gradually lower it on to the work with a slight forward
movement .
▪ Move the sander slowly over the work piece using forward and back or side to side
strokes.
▪ Upon completion of the sanding operation remove the sander from the work piece before
turning if off.
7.2 Switching On-off (Fig. 1)
Connect the plug to the power supply.
▪ Switch the power tool on: push the ON/OFF switch button (1) forwards onto the “I”
position.
▪ Switch the power tool off: pull the ON/OFF switch button backwards to the “O” position.
WARNING: Never use the machine for sanding magnesium work piece.
7.3 Replace and install the round / iron-shaped / rectangular sanding base (Fig. 2)
NOTE: There are three sanding bases (round / iron-shaped / rectangular)
that suitable for requirements or statuses of the different sanding work.
Important: Prior to any assembly and adjustment always unplug the tool.
▪ Remove the round sanding base (6) from the sander by loosening the four screws.
▪ Fixed four rubber column onto the iron-shaped base (7) or rectangular base (8) with four
screws, and then put the iron-shaped base (7) or rectangular base (8) onto the tool, using
four other screws to fixed in the suitable position and tighten the screws.
▪ Remove the sanding base (round / iron-shaped / rectangular) in the opposite way.
NOTE: the round sanding base and rectangular sanding base must be
equipped with four rubber column before install onto the tool.
