POWX0260 EN
Copyright © 2019 VARO P a g e | 5 www.varo.com
7 OPERATION
WARNING: Prior to assembly and adjustment always pull out the power plug
from the mains socket.
7.1 Changing drill or screwdriver bit
▪ Insert the chuck key in one of the three holes on the side of the chuck (1), turn to open.
▪ Insert the desired drill or screwdriver bit in the chuck and turn the chuck key the opposite
way until the chuck has a firm grip on the drill or screwdriver bit.
▪ Check that the drill or screwdriver bit is in the centre of the chuck and is secure.
7.2 Switching on/off (Fig. 1)
▪ Plug the cord set into power socket.
▪ Start the tool by squeezing the ON/OFF switch (8).
▪ Release the ON/OFF switch to stop the tool.
▪ If you press the lock-on button (7) while the ON/OFF switch is depressed, the ON/OFF
switch is kept in the operating position.
▪ To release the ON/OFF switch (8) and turn the tool off.
7.3 Forward/reverse lever (Fig. 2)
▪ The forward/reverse lever (5) is to determine the rotation direction of the chuck.
▪ To select forward rotation, release the ON/OFF switch (8) and push the forward/reverse
lever to right (R) side of the tool. To select reverse rotation, push the lever to left (L) side
of the tool.
NOTE: When changing the position of the lever, be sure the ON/OFF switch
is released and the motor is stationary.
7.4 Variable speed (Fig. 3)
This tool has a speed control dial (6) that delivers higher speed by turning to the “+” direction,
and delivers lower speed by turning to “-”direction.
7.5 Drill or impact mode selector (Fig. 4)
The drill and impact mode selector is on the top of this impact drill.
▪ Push the button of drill /impact mode selector (4) to the “ ” to select the impact mode of
action.
▪ Push the button of drill/impact mode selector to the drill position “ ” to select the drill mode
of action.
