POWX00408 EN
Copyright © 2022 VARO P a g e | 7 www.varo.com
▪ The charging process starts as soon as the USB A charging cable plug is inserted in
the USB A port.
▪ The charging LED light (11), lights up red to during the charging procedure. The
battery is fully charged when the red indicator turns green.
During the charging procedure, the handle of the machine warms up. This
is normal.
When the charging is finished, disconnect the battery charger from the
socket.
Do not use the machine during the charging procedure.
7.2 Inserting and extracting bits (Fig. C)
Important! Always lock the trigger switch before you change the screw bit to avoid
unintentional starting of the machine (see paragraph 7.3). When the machine is
completely stopped, insert or extract the screw bit.
Only use tool bits which can be securely fastened in the chuck and for
which the bits has been designed.
Before using the machine check whether the screw-bit is inserted correctly.
Avoid over-tightening screws, otherwise the screw head may be damaged
or stripping of the threads may occur.
7.3 Trigger switch (Fig. A)
▪ Use the trigger switch (4) to start the machine and keep holding it for continuous
operation.
▪ To switch the machine off, release the trigger switch (4)
▪ To lock the trigger switch (4), set the direction of rotation selector (3) at the centre
position.
7.4 Working spot light (Fig. A)
▪ Pushing the operating button will turn on the working spot light.
▪ Leaving the operating button will switch off the working spot light.
7.5 Direction of rotation
Direction of rotation is controlled by the direction of rotation selector ( ) located above the
trigger switch.
7.5.1 Clockwise rotation:
To select clockwise rotation, release the trigger switch and push the direction of rotation
selector (3) to the left side of the tool.
7.5.2 Anticlockwise rotation:
To select anticlockwise rotation, release the trigger switch and push the selector (3) lever
to the right side of the tool.
7.6 Screw insertion
Set the direction of rotation (3) of the screwdriver to the clockwise direction. Insert the screw-
bit into the slot in the head of the screw. Hold the screw bit perpendicular to the head of the
screw, otherwise the screw or the screw head may be damaged. Press the screw bit against
the screw with a constant pressure while driving in the screw.
