POWPG10240 EN
Copyright © 2020 VARO P a g e | 11 www.varo.com
11 BLADE
The blade is made of pressed steel. It will be necessary to reshape it frequently(with a grind
wheel).
Ensure that it is always balanced (an unbalanced blade will cause dangerous vibrations). To
check for balance, insert a round rod through the central hole and support the blade
horizontally. A balance blade will remain horizontal. If the blade is not balanced the heavy end
will rotate downwards. Reshape the heavy end until the blade is currently balanced. To
remove the blade, unscrew the blade screw.
Check the conditions of the fan, and replace any parts, which are damaged.
When reassembling, make sure that the cutting edges face in the direction of the motor
rotation. The blade screw must be torque to 25NM.
12 EXTENSION CORDS
You should only use extension cords for outdoor use, PVC ordinary duty with a cross sectional
area not less than 1.0mm².
Before using, check the supply and extension cords for signs of damaged during use,
disconnect the cord for signs of damage or aging. If the cord becomes damaged during use,
disconnect the cord from the supply immediately. DO NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY. Do not use the appliance if the cord is damaged or worn.
Keep extension cord away from cutting elements.
Warning: Always ensure that the ventilation openings are kept clear of
debris.
We wish to thank you for choosing our products. We are confident that he high quality of our
machine will meet with your satisfaction and appreciation and that we will give you long-lasting
service.
Before starting to use your machine, make sure to read with care this manual, which has been
purposely drawn up to provide you with all the necessary information for proper use, in
compliance with basic safety requirements.
13 CLEANING AND MAINTENANCE
Warning: Before performing any Maintenance or cleaning work, Always pull
out the mains plug!
Do not spray the unit with water. Ingress of water may destroy the Switch-plug combination
unit and the electric motor. Clean the unit with a cloth, hand brush, etc.
Expert inspection is required, do not make any adjustment by yourself, must contact to
customer Service centre:
▪ If the lawn mower strikes an object.
▪ If the motor stops suddenly
▪ If the blade is bent (do not align!)
▪ If the motor shaft is bent (do not align!)
▪ If a short-circuit occurs when the cable is connected.
▪ If the gears are damaged.
▪ If the v-belt is defective.
