POWP6080 EN
Copyright © 2018 VARO NV P a g e | 7 www.varo.com
Make sure that the tool is switched off and the nozzle has cooled down.
Set the desired accessory onto the nozzle.
8.7 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting
to move or store the tool.
Place this hot air gun vertically during cooling time or rest after operation.
▪ To reduce the cooling time, switch the tool on at position ‘I’ and let in run for a few
minutes.
▪ Switch the tool off and let it cool down for at least 30 minutes.
9 MAINTENANCE AND CLEANING
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2 Lubrication
Your power tool requires no additional lubrication
10 TECHNICAL DATA
11 ENVIRONMENT
Should your appliance need replacement after extended use, do not discard it with
the household rubbish but dispose of it in an environmentally safe way.
Waste produced by electrical machine items should not be handled like normal
household rubbish. Please recycle where recycle facilities exist. Check with your
Local Authority or retailer for recycling advice.
