POWEG9013 EN
Copyright © 2020 VARO P a g e | 5 www.varo.com
6 SPECIFIC SAFETY INSTRUCTIONS
▪ Make sure the power cord is kept behind and away from the device while you work.
▪ Always position yourself horizontally to the slope and make sure your feet are firmly planted.
Exercise particular caution whenever you change directions while working on a slope.
▪ Walk at a measured pace while operating the blower. DO NOT RUN.
▪ Never direct the suction/blown air opening toward persons or animals.
▪ The blow/vac must not be used or starting until it has been fully assembled.
▪ Make sure the power cord is kept behind and away from the device while you work.
▪ If the power cord or extension cord are damaged while you work, unplug the blower immediately.
▪ Never use the power cord as a handle to lift or carry the device.
▪ Always unplug the device under the following circumstances:
▪ When the blower is not in use, is being carried/transported, or is left unattended.
▪ While examining, cleaning or unclogging the device.
▪ When cleaning the device, performing maintenance on it, or attaching accessories to it.
▪ If the device strikes a foreign object or begins vibrating abnormally.
▪ Use the blower in daylight or with adequate illumination.
▪ Bear in mind that the force generated by an electrical device can make you lose your balance.
Therefore, make sure that your feet are firmly planted and that your body is well balanced when
you are operating the device.
▪ Never operate the blower on damp or wet grass.
▪ Using the blower on sloping areas: Do not work in areas with unduly steep slopes.
▪ Use the blower as follows when working on slopes:
▪ Keep the air outlet unobstructed and clean at all times.
▪ Never direct the suction/blown air opening toward persons or animals.
7 ASSEMBLY
1. Your new blow/vac requires very little assembly work before it is ready for use.
Warning: if any part is missing or damaged, do not plug in the machine until you have
replaced the missing or damaged part.
7.1 Assembling the tubes (Fig. 1, 2)
▪ Slide the top tube section into the motor housing, use two short screws to fix the tube on both
sides of the motor housing, tighten the screws and make sure the tube is firmly fixed into the motor
housing.
▪ Insert the bottom section tube into the top section tube and push them until they are connected
firmly together. Finally tighten the screws on both sides.
7.2 Shoulder belt
▪ Attach the shoulder belt to the foreseen hook on the handle. To adjust the shoulder belt to the
required length, simply slide the adjustable strap buckle forward or backwards.
7.3 Collection bag (Fig. 3)
▪ Before fitting the collection bag ensure that the blow - vacuum function selector lever operates
smoothly and that it is not obstructed by debris from the previous use.
▪ Secure the hook of the collection bag to the tube and then install the entrance of debris of the
collection bag in the foreseen opening.
