POWEG8050 EN
Copyright © 2022 VARO P a g e | 22 www.varo.com
▪ Always turn the appliance off before performing any maintenance work and remove the
spark plug connector (12).
13.1 Storing the appliance
The appliance must be prepared for storage if it is to be stored for longer than 30 days.
Otherwise the residual fuel in the carburettor will evaporate and leave a gooey sediment. This
may make starting the appliance more difficult and result in expensive repair work.
▪ Remove the filler cap (16) to relieve any pressure in the fuel tank (15).Carefully empty the
fuel tank (15).
▪ To remove all fuel from the carburetor, start the engine and leave it to run until it stops.
▪ Allow the engine to cool for about 10 minutes.
▪ Remove the spark plug (see section "Spark plug maintenance").
▪ Add 1 teaspoon of 2-stroke oil to the combustion chamber. Pull the starter pull cord (14)
several times in order to wet all mechanical parts with oil. Replace the spark plug.
2 N
NOTE: Store the appliance in a dry place and away from possible ignition
Sources.
13.2 Start-up after storage
▪ Remove the spark plug (see section "Spark plug maintenance").
▪ Pull the starter pull cord (14) quickly in order to remove any excess oil from the
combustion chamber.
▪ Clean the spark plug and observe the correct electrode gap on the spark plug.
▪ Fill the fuel tank (15). See the section "Fuel and oil".
13.3 Transporting
▪ if you are planning to transport the appliance, empty the fuel tank (15) as explained in the
section "Storage".
