POWDPG8060 EN
Copyright © 2021 VARO P a g e | 8 www.varo.com
8.2 Removal / insertion of battery
WARNING: Before making any adjustments ensure the tool is switched off or
remove the battery pack.
▪ Hold the tool with one hand and the battery pack (5) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3 Battery capacity indicator (Fig. B)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button. Before using the machine, please press switch trigger
(2) to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
▪ 3 LED’s are lit: Battery fully charged.
▪ 2 LED’s are lit: Battery 60% charged.
▪ 1 LED is lit: Battery almost discharged.
9 ASSEMBLY
The Weed sweeper is supplied with some components which need to be assembled. Please
proceed as follows:
9.1 Mounting of the brush cover (Fig. 1-2)
Slide the brush cover (10) along the guide rails (19) on the motor head (13) until it clicks.
9.2 Inserting/replacing the brush (Fig. 3)
1 Push the brush support ring (18) towards the motor head (13) and insert the desired
brush.
2 Release the brush support ring (18) to let it return to the initial position.
3 To remove the brush, push the brush support ring (18) and remove the brush.
The spare brush is released from the spare brush holder (20) by pressing the
release button (16) (Fig. 4).
The spare brush is fixed into the holder by pressing the brush with the hexagon into the
hexagon slot of the holder (16) until it clicks. (Fig. 4)
9.3 Mounting the additional handle (Fig. 5)
1 Unscrew the additional handle screw (6).
2 Insert the additional handle (17) into the holder underneath the handle (1).
3 The spare brush holder (20) must point towards the telescopic tube (8).
4 Screw the additional handle (17) tightly with the star-stud screw (6).
5 The additional handle is rotatable and can be adjusted in height.
9.4 Unit assembly (Fig. 6)
1 Unfasten the screw socket (7) and place the telescopic tube (8) into the screw socket (7).
2 Insert the telescopic tube (8) into the screw socket (9).
3 Turn the screw socket (9) until it is hand-tight.
If the telescopic tube (8) is not tight totally, the appliance will not start!
