POWDPG7540 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3 Battery capacity indicator (Fig. 1)
There are battery capacity indicators (19) on the battery pack, you can check the capacity status
of the battery if you squeeze the button (20). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
▪ 3 LED’s are litt: Battery fully charged.
▪ 2 LED’s are litt: Battery 60% charged.
▪ 1 LED is litt: Battery almost discharged.
9 ASSEMBLY
The grass trimmer is supplied with some components not assembled. To assemble these
proceed as follows:
9.1 Mounting the guard
▪ Fix the safety guard to the trimmer head making sure the sides are located into the
grooves on the trimmer head.
▪ Secure the safety guard onto the trimmer head with the screws provided.
▪ Remove the warning label sticker from the cutter blade immediately after mounting the
guard.
Caution! During this operation beware of the line cutter blade. You may be
wounded.
Caution! Never use the grass trimmer without the guard. It is vital for your
and other peoples’ safety and for the good working order of the trimmer. The
failure to observe this safety regulation is not only dangerous but also annuls
the guarantee terms.
9.2 Height adjustment (Fig. 2)
▪ To adjust the height, simply rotate and loosen the collar extension lock knob (5) as arrow 1
shown and to extend or retract the extension tube (6) as arrow 2 shown.
▪ Tighten the extension lock knob (5) to lock the tube on the selected position.
9.3 Setting the auxiliary handle (Fig. 3)
▪ Squeeze the adjustment button of auxiliary handle (4).
▪ Turn the auxiliary handle (3) until the most balanced and most comfortable position.
▪ Then tighten the adjustment button of auxiliary handle (4) to the chosen position.
9.4 Adjustment the cutting angle (Fig. 4)
Your Trimmers has a 3-positions cutting head. This setting allows you to work effectively at a
comfortable working angle. It can cut accurately around the flower beds, under bushes, around
trees and fence posts etc.
To change the angle, simply press the head angle button (8) of the cutting head, to the engine
block to the desired position, then release the button.
Warning: remove the battery pack from the trimmers before handling setting.
