POWDP35100 EN
Copyright © 2022 VARO P a g e | 9 www.varo.com
Note: If the protective guard cannot be fixed firmly by the lock lever (4), use
a hexagon wrench to tighten the hexagon nut.
Warning: the protective guard must be positioned to protect the user if the
disc shatters during use.
9.3 Replacing the grinding disc (Fig. 6a-7b)
Beware – a disc which has been used may be very hot!
Warning: prior to assembly and adjustment always pull out the battery pack
from the grinder body.
▪ Depress and hold down the spindle lock button (2) to secure the spindle.
▪ Turn the spindle until it locks.
▪ Remove the outer flange and the disc, the inner flange can remain in place.
▪ Always check if the inner flange is slotted correctly on to the spindle using the
corresponding slots on both spindle and flange. (Fig. 6a - 6b)
▪ Place the alternate disc you want to use on top of the inner flange and check the disc
manufacturer instructions for the correct orientation of the disc. (Fig. 7a)
▪ Screw the outer flange back on to the spindle and fasten it with the wrench. (Fig. 7b)
▪ Make sure using the spindle lock that the disc cannot slip.
Important! Only ever press the spindle lock when the motor and grinding
spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel!
Switch the grinder on using the ON/OFF switch (3+9), and let it run for 30 seconds to check
that it is working correctly and that there are no abnormal vibrations. Stop the grinder
immediately if heavy vibration occurs, and investigate the cause.
For grinding disc and cutting wheel with a thickness up to approx. 3 mm, screw on the outer
flange with the flat side facing the grinding disc or cutting wheel.
10 OPERATION
10.1 Switch on/off (Fig. 8)
Before engage the ON/OFF switch button, check that the grinding disc is
properly fitted and run smoothly, the outer flange is well tightened.
▪ Connect the battery pack onto the angle grinder body.
10.1.1 Switching on
Push the safety switch (3) forward to unlock the ON/OFF switch, afterwards depress the
ON/OFF switch (9) completely.
10.1.2 Switching off
Release the ON/OFF switch (9). The safety switch (3) will automatically return to the locked
position.
