POWDP2580 EN
Copyright © 2022 VARO P a g e | 7 www.varo.com
▪ Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
▪ Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5 Battery tool use and care
▪ Recharge only with the charger specified by the manufacturer. A charger that is suitable
for one type of battery pack may create a risk of fire when used with another battery
pack.
▪ Use power tools only with specifically designated battery packs. Use of any other battery
packs may create a risk of injury and fire.
▪ When battery pack is not in use, keep it away from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal objects, that can make a connection from
one terminal to another. Shorting the battery terminals together may cause burns or a
fire.
▪ Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or burns.
▪ Do not use a battery pack or tool that is damaged or modified. Damaged or modified
batteries may exhibit unpredictable behaviour resulting in fire, explosion or risk of injury.
▪ Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or
temperature above 130 °C may cause explosion.
▪ Follow all charging instructions and do not charge the battery pack or tool outside the
temperature range specified in the instructions. Charging improperly or at temperatures
outside the specified range may damage the battery and increase the risk of fire.
5.6 Service
▪ Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 ADDITIONAL SAFETY INSTRUCTIONS FOR TABLE SAWS
6.1 Guard related warnings
▪ Keep guards in place. Guards must be in working order and be properly mounted.
▪ Always use saw blade guard, riving knife for every through–cutting operation.
▪ Immediately reattach the guarding system after completing an operation (such as
resawing cuts) which requires removal of the guard, riving knife.
▪ Make sure the saw blade is not contacting the guard, riving knife or the workpiece before
the switch is turned on.
▪ Adjust the riving knife as described in this instruction manual.
▪ For the riving knife to work, they must be engaged in the workpiece.
▪ Use the appropriate saw blade for the riving knife.
6.2 Cutting procedures warnings
Never place your fingers or hands in the vicinity or in line with the saw
blade.
▪ Feed the workpiece into the saw blade or cutter only against the direction of rotation.
▪ Never use the mitre gauge to feed the workpiece when ripping and do not use the rip
fence as a length stop when cross cutting with the mitre gauge.
