POWDP2530 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
9.2 Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the hedge trimmer is
switched off or remove the battery pack.
▪ Hold the tool with one hand and the battery pack (11) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
9.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button. Before using the machine, please press switch trigger to
check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LED’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
10 OPERATION
10.1 Replacing saw blades (Fig. 4)
Disconnect the battery pack (11) from the cordless jig saw.
▪ Pull the lever of quick-change blade clamping holder.
▪ Slide the saw blade (8) into the locating groove with teeth pointing forward. Make sure that
the back edge of the blade fits into the blade clamping holder (7) and then release the
lever of quick-change blade clamping holder.
NOTE: Make sure that the back of the saw blade engages in the slot of the
guide roller (6).
▪ Mounting battery pack (11) onto jig saw’s body and runs smoothly before using it to cut
any materials.
10.2 Angle cutting adjustment (Fig 5)
▪ The base plate (15) can be adjusted 45° (left or right) in relation to the saw direction to
facilitate contour sawing.
