POWDP15680 EN
Copyright © 2022 VARO P a g e | 9 www.varo.com
NOTE: Remove battery pack from charger stand which use your thumb or
fingers, press the battery’s release button in and pull the battery pack off at
the same time.
9.2 Battery capacity indicator (Fig. 2)
There are battery capacity indicators on the battery pack; you can check the capacity status of
the battery if you squeeze the button (13). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged.
2 LED’s are litt: Battery 60% charged.
1 LED is litt: Battery almost discharged.
9.3 Inserting and removing the battery (Fig. 3)
WARNING: Before making any adjustments ensure the drill is switched off
with the direction of rotation selector in the centre position
▪ Remove the battery: press the battery release button in and at the same time pull the
battery pack off.
▪ To insert the battery, push the battery pack onto the contacts of the tool.
9.4 Fitting and changing tools (Fig. 4)
The device is equipped with a SDS-plus attachment system.
▪ Clean tools and grease with a thin layer of machine grease before fitting.
▪ Fit the desired bit into the bit holder.
▪ Push and rotate the dust-free tool into the tool holder as far as it will go. The tool will lock
automatically.
▪ Check that it has locked by pulling the tool
9.5 Removing SDS-plus tool (Fig. 5)
Pull back fastening sleeve (2), hold and remove tool.
Accessories can be hot after use. Don’t touch the tip of accessory by hand!
Please always use protective gloves to remove accessories.
9.6 Auxiliary handle (Fig. 6)
For reasons of safety, only use the hammer drill with auxiliary handle.
You will be able to obtain a safe body position when working by rotating the auxiliary handle.
Loosen and turn the auxiliary handle in an ant-clockwise direction. Slip loop onto the neck of
the housing tool and position the handle, then tighten the auxiliary handle.
9.7 Depth stop (6) (Fig. 7)
Loosen the auxiliary handle and place the straight part of the depth stop in the hole. Adjust the
depth stop and retighten the auxiliary handle.
9.8 Dust cap (1) (Fig. 8)
Slide the dust cap (1) over the drill bit before carrying out any hammer drilling vertically above
your head.