9'(,?')#6'@)$$%/'3'()*+,#%'-.%/)$,#0'()#1)2'
7)0%'4:'3''
hole which is located in the floor of the bag chamber. Let the
body of the bag lie on the floor of the bag chamber.
2 Slowly feed the batter away from the tail end of the bag by
gently squeezing the batter up toward the middle of the bag
and locate the tail of the bag between the two rods located in
the bag chamber. It may be easier to first insert one side of
the tail and then pull the rest of the tail through between the
rods into position. Ensure that the bag is parallel with the
sides of the chamber and that the bag tail is pulled as far
through between the rods as is practical.
3 Using your hand gently distribute the batter evenly through
out the bag.
4 Slowly lower the lid of the machine. To close the lid, lift the
latch and then release it. You should hear an audible click.
5 If an inflated bag prevents the lid from closing easily, remove
the bag, release the built up gasses and then reload the bag.
6 Once the lid is closed, follow the instructions on the control
panel display.
Unloading a bag from the machine
1 Following the instructions shown on the machine display,
open the lid of the machine and remove the bag. Upon
opening the lid, the bag will be seen in the bag chamber with
the bag nozzle located on the hole in the floor of the
chamber.
Remove the bag from the machine by firstly pulling the tail of
the bag out from between the rods and then using both
hands, one on each side of the bag nozzle, pull the nozzle up
out of the hole in the floor of the bag chamber.
2 If the bag removed from the machine is empty dispose of it
responsibly or if it still contains usable batter store the bag in
line with the “Mix and batter storage, use and care
recommendations” on page 15.
