Handleiding Polti Vaporella Silence Friendly 8.80 (pagina 10 van 15) (Engels)

648733

Verklein

Vergroot

Pagina terug

1/15

Pagina verder

ENGLISH

| 22 |

1. PREPARATION FOR USE

1.1 Place the boiler on a firm, flat and heat-resistant surface.

1.2 Remove the self-filling tank lid (1) and fill the tank with about

1.2l of water, making sure that it does not overflow.

This operation must always be carried with the power cable

disconnected from the mains.

Thanks to the continuous refill system you do not need to stop the

ironing and wait for the appliance to cool down because the tank

can be filled as needed.

1.3 Replace the lid.

1.4 Connect the cable plug to an earthed power supply of the

correct voltage (2).

1.5 Press the ON/OFF switch (located on the side of the

machine) (3). The ON indicator light and the “Iron heating”

indicator light will turn on.

1.6 Press the boiler switch (4). The “steam ready” and boiler

indicator lights will come on.

2. IRON TEMPERATURE ADJUSTMENT

Before ironing an item of clothing, always check the symbols

on its label, for the instructions provided by the manufacturer.

Check, based on the following table, the most appropriate type

of ironing:

3. STEAM IRONING

3.1 Make sure that chapter 1 has been completed and regulate

the temperature of the iron (5)-(6) as described in chapter 2.

3.2 Wait for the “Steam Ready” indicator light and “Iron

Heating” indicator light to turn off (about 3 minutes).

3.3 Adjust the steam flow by turning the knob in a clockwise

direction to increase the jet of steam (7). Turning it in an

anticlockwise direction reduces the steam flow.

3.4 Press the steam button (8) on the iron to make steam come

out of the holes on the plate. Releasing the button, the flow

stops. Proceed to iron the garments.

3.5 To have a continuous jet of steam move the button forward

(9). The steam will continue to come out even when the button

is released. To interrupt the supply, move the button backward

(9).

4. VERTICAL IRONING

It is possible to use the iron vertically to remove creases from

fabrics and/or to freshen up the fibres, eliminating possible

residual odours.

Hold the iron vertically, push the steam button (8) and touch the

fabric slightly with the soleplate, if the type of fabrics allows it.

5. DRY IRONING

5.1 Make sure that chapter 1 has been completed, leaving the

boiler switch off and regulate the temperature of the iron (5)-

(6) as described in chapter 2.

During dry ironing, if the boiler button is ON, take care not to

push the steam release button on the Iron since some water

drops can come out from the soleplate

ATTENTION: Do not place the hot iron on any surface.

Vaporella is equipped with an iron rest mat with soft non-slip

inserts designed to resist high temperatures.

The indicator lights “Iron heating” turn on and off during use.

This indicates that the electrical resistor has started to work to

keep the pressure of the boiler steady. This is a normal

occurrence, and it is therefore possible to continue ironing.

When first using the steam, there may be some drops of water

leaking out of the plate, this is due to imperfect thermal

stabilization. We therefore recommend that the first jet of

steam be directed onto a cloth (clean rag).

Divide the laundry according to the symbols on the garment

labels or according to the kind of fabric. Always start ironing

with the garments that require the lowest temperature, in

order to reduce the waiting times and avoid the risk of burning

the fabrics.

ATTENTION: For low temperature we do not recommend the

use of steam since water could come out from the holes on the

soleplate. For medium temperature alternate the use of steam

and dry ironing to avoid water leaking from the holes on the

soleplate.

High temperature – cotton, linen:

Set the iron temperature adjustment knob to the position

•••

Medium temperature – wool, silk:

Set the iron temperature adjustment knob to the position

••

Low temperature – synthetic, acrylic, nylon, polyester:

Set the iron temperature adjustment knob to the position •

- Do not iron

- Steam ironing and steam treatment not allowed

WARNING: When first operating steam, there may be some

drops of water mixed with the steam due to temperature

imbalances.

Direct the first jet of steam onto a rag.

The sound emitted on switching on your appliance and

periodically during use, is due to the water refilling system and

is quite normal.

PRELIMINARE VL FOREVER 8.85-8.80 - 1P05_vers7:UNICO 17/07/2015 15.37 Pagina 22

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Polti Vaporella Silence Friendly 8.80 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Polti Vaporella Silence Friendly 8.80

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info