Handleiding Polti Vaporella Prof 1100 (pagina 3 van 3) (Engels)

648828

Verklein

Vergroot

Pagina terug

1/3

Pagina verder

Appropriate separate collection to permit recycling, treatment and

environmentally compatible disposal helps prevent negative im-

pact on the environment and human health and promotes recy-

cling of the materials making up the product. For more information

on available collection facilities, contact your local waste collection

service or the shop where you bought this appliance.

1a.Unscrew the patented safety cap (5) and fill the boiler with

about 0.9 litres of water using the special funnel (9) making

sure that it does not overflow (fig. 1).

Normal tapwater can be used. However, as water by its nature

contains limestone, which may cause build-up of limescale in

the boiler, in hard water areas we recommend the use of our

natural-base decalcifier Kalstop FP 2003.

2a. Screw the cap fully and carefully. Make sure the patented safe-

ty cap (5) is fully and correctly screwed on, otherwise you may

experience steam escaping from the cap.

3a.Connect the power cable into an earthed power supply of the

correct voltage.

4a.Switch on the boiler and iron by pressing the switches (2) and

(4) (fig. 2).

NOTE: during the filling operation, be careful that the water does

not overflow as it may come out and wet the surface where

Vaporella is laid.

Before ironing a garment, it is always a good idea to check the

symbols appearing on the label and the instructions provided by

the garment manufacturer.

Check which kind of ironing is recommended, referring to the table

below:

STEAM IRONING

1b.Set the iron temperature on the “COTTON - LINEN” position

(fig. 3), by turning the knob (1).

2b.Wait until the boiler switch (2) and the “Iron heating” indicator

light (3a) switch off (about 15 minutes). Press the button (3) on

the iron to make steam come out of the holes on the solepla-

te. Releasing the button, the steam stops (fig. 4).

NOTE: during initial operation of the iron, a few drops of water

mixed with steam may come out of the soleplate until the tem-

perature stabilizes. It is advisable to direct the first jets of

steam onto an old cloth until a uniform stable jet of steam is

obtained.

DRY IRONING

1c. For dry ironing:

• Plug the cable in.

• Press the iron switch (4), leaving the boiler switch (2) off .

• Adjust the soleplate temperature by turning the knob (1), set

the temperature according to the kind of fabric.

NOTE:

• The boiler switch (2) and the “Iron heating” indicator light (3a) go

on and off during usage. This means that the heating element is

working correctly to keep a constant pressure in the boiler. This

is a correct functioning, just continue ironing as usual.

• If no steam comes out of the iron, check the following: the “Iron

heating” indicator light (3a) is OFF; there is water in the boiler.

““

””

Your Vaporella is equipped with the unique Polti patented safety

cap, which prevents opening of the boiler as long as there is any

pressure remaining inside the tank. This is an important and indi-

spensable safety device, and it is necessary to follow certain pro-

cedures when re-filling the boiler.

When no more water comes out of the iron, do as follows:

1d.Switch off the boiler (2).

2d Press the steam button on the iron (3) so as to fully exhaust

the steam supply from the boiler.

3d.Switch off the iron (4) .

4d.Disconnect the power cable from the mains.

5d.Unscrew anti-clockwise the patented safety cap (5).

6d.Wait for a few minutes allowing the boiler to cool down.

7d.When cool, carefully refill the boiler as described in paragraph

1a of the section “PREPARATION FOR USE”. If you refill the

boiler when not completely cooled, we recommend to pour

only very small quantities of water, so as to avoid its immedia-

te evaporation.

• Before attempting any maintenance operation, always

disconnect the appliance from the mains.

• To clean the body of the appliance, simply use a moist cloth. Do

not use solvents or detergents which may harm the body mate-

rial.

FOR YOUR OWN SAFETY READ FOLLOWING INSTRUCTIONS

CAREFULLY BEFORE ATTEMPTING TO CONNECT THIS UNIT

TO THE MAINS.

((

))

((

))

This unit is designed to operate on 240V, 50 Hz current only.

Connecting it to other power sources may damage the unit.

WARNING - This appliance must be earthed.

This appliance may be fitted with a non rewirable plug, if it is neces-

sary to change the fuse in a non rewirable plug the fuse cover must

be refitted. If the fuse cover is lost or damaged, the plug must not be

used until a replacement, available from the appliance manufactur-

er, is obtained. It is important that the colour of the replacement fuse

cover corresponds with the colour marking on the base of the plug.

If the plug requires to be changed because it is not suitable for your

socket, or becomes damaged, it should be cut off and an appropri-

ate plug fitted following the wiring instruction (below). The plug

removed must be disposed of safely as insertion into a 13Asocket

is likely to cause an electrical hazard.

IMPOR-

TANT

This

wires in

this

mains

lead are

coloured

in accor-

dance

with the

following

code.

• Green-

and-yel-

low: Earth

• Blue: Neutral

• Brown: Live

As the colours of the wires in the mains leads of this appliance

may not correspond with the coloured markings identifying the ter-

minals in your plug, proceed as follows:

The wire which is coloured green-and-yellow must be connected

to the terminal in the plug which is marked with the letter “E” or by

the earth symbol or green-and-yellow.

The wire which is coloured blue must be connected to the terminal

which is marked with the letter “N” or coloured black.

The wire which is coloured brown must be connected to the termi-

nal which is marked with the letter “L” or colouredred.

GREEN

YELLOW

(Earth)

BLUE

(Neutral)

FUSE

(13 amp)

BRAWN

(Live)

Steam ironing allowed

For dry ironing, set thermostat on •••

Steam ironing allowed

For dry ironing, set thermostat on ••

Check the fabric's resistance to steam iro-

ning or dry iron with thermostat set on •

- do not iron

- steam ironing or treatment not allowed

Polti Vaporella Prof 1100 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Polti Vaporella Prof 1100

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info