Section 4. Using Your PX-716
PX-716 Installation and Users Manual 49
Tray Loading and Operation
To load and unload the tray:
1. While the drive is powered up, push the eject button on the front
panel. The tray drawer slides out in 3–4 seconds.
Figure 27: Loading the tray
2. Lay a CD or DVD disc in the depression in the tray, label side up.
3. Press the eject button again and the tray will slide shut within
seconds.
NOTE: Always use the eject button to close the tray in a smooth and
secure manner. Closing the tray by pressing the front of the drawer using
your hand is not recommended and risks damage or premature wearing
of the mechanism.
Handling DVD and CD Media
Take care when handling blank CD and DVD media. Dust, scratches,
and fingerprints on either side of the disc can cause write errors during
recording. When picking up or holding blank media you can either place
your fingers along the outer edge of the disc, or place one finger through
the center hole and one finger on the outer edge. Once you have finished
creating a disc, label it by writing on the top using permanent ink.
CAUTION: We recommend using a “non-toxic” marker, such as a
Sharpie pen, that conforms to the ASTM D-4236 standard. Some
permanent markers will damage the media. Also, do not press too hard
when writing on the disc.
