Audio Adjustments
Adjusting 3-band parametric equalizer
For CUSTOM1 and CUSTOM2 equalizer
curves, you can adjust the front, rear and center
equalizer curves separately by selecting a cen-
ter frequency, an equalizer level and a Q factor
for each band.
• A separate CUSTOM1 curve can be created
for each source.
•A CUSTOM2 curve can be created common
to all sources.
• The center speaker largely determines the
sound image and getting the balance right isn’t
easy. We recommend reproducing a 2-ch. audio
(a CD for example) and getting the balance right
among the speakers except for the center, and
then reproducing a 5.1-ch. audio (Dolby Digital
or DTS) and adjusting the center speaker output
to the balance you have already got among the
other speakers.
1 Press AUDIO and hold until SP Set
appears in the display, then press AUDIO to
select PEQ.
After SP Set is displayed, press AUDIO until
PEQ appears in the display.
• You cannot select PEQ when neither CUS-
TOM1 nor CUSTOM2 equalizer curve is
selected.
2 Press 2 or 3 to select the speaker selec-
tion mode.
Each press of 2 or 3 selects the item in the
following order:
FRONT (speakers)—Low (bands)—Low (cen-
ter frequency)—L (equalizer level)—Q.WIDE (Q
factor)
3 Press 5 or ∞ to select the speaker to be
adjusted.
Each press of 5 or ∞ selects the speaker in the
following order:
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)
• You cannot select speakers whose size is set
OFF.
4 Press 3 and then press 5 or ∞ to select the
equalizer band to be adjusted.
Each press of 5 or ∞ selects the equalizer band
in the following order:
Low (low)—Mid (mid)—High (high)
5 Press 3 and then press 5 or ∞ to select the
center frequency of selected band.
Each press of 5 or ∞ selects the frequency in
the following order:
100—125—160—200—250—315—400—500—
630—800—1k—1.25k—1.6k—2k—2.5k—
3.15k—4k—5k—6.3k—8k (Hz)
6 Press 3 and then press 5 or ∞ to adjust
the equalizer level.
Each press of 5 or ∞ increases or decreases
the equalizer level.
• +6 — –6 is displayed as the level is increased
or decreased.
7 Press 3 and then press 5 or ∞ to select the
desired Q factor.
Each press 5 or ∞ switches between the follow-
ing Q factor:
Q.WIDE (wide)—Q.NAR. (narrow)
• You can adjust parameters for each band of
the other speakers in the same way.
8 Press BAND/ESC to return to the playback
display.
Note
• You can select a center frequency from
among 20 frequencies for each band. You can
change the center frequency in 1/3-octave
steps, but you cannot select frequencies so
that there are intervals shorter than 1 octave
among the three bands’ center frequencies.
En
14
02
Section
