Installing the battery
Slide the tray out on the back of the remote con-
trol and insert the battery with the plus (+) and
minus (–) poles pointing in the proper direction.
• When using for the first time, pull out the film
protruding from the tray.
WARNING
• Keep the battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
CAUTION
• Use only one CR2025 (3V) lithium battery.
• Remove the battery if the remote controller is
not used for a month or longer.
• Do not recharge, disassemble, heat or dispose
of the battery in fire.
• Do not handle the battery with metallic tools.
• Do not store the battery with metallic materi-
als.
• In the event of battery leakage, wipe the
remote control completely clean and install a
new battery.
• When disposing of used batteries, please
comply with governmental regulations or envi-
ronmental public institution’s rules that apply
in your country/area.
• Always check carefully that you are loading
battery with its (+) and (–) poles facing in the
proper directions.
• Do not leave this unit free inside the car. When
the car stops or turns a curve, the unit might
drop on the floor. If the unit is rolled and put
under the brake pedal, it might prevent the
driver from braking well, causing a serious
trouble.
• Do not disassemble or modify this unit. To do
so may cause a fault.
• The volume of the car stereo should be so
adjusted that you can hear a loud sound
occurring outside your car. If any happening
sound outside your car is deafened by music
from the car stereo when you are driving, this
condition can be a factor of being involved in a
traffic accident.
Before you start
Using the remote control
operation mode switch
There are three remote control operation modes
on this remote control.
AVH mode operation
When operating an AV-Receiver (e.g. AVH-
P5700DVD) with this remote control, remote
control operation mode switch is normally
switched to AVH.
DVD mode operation
When operating a Pioneer DVD player with this
remote control, operation mode switch is nor-
mally switched to DVD. If you switch the remote
control operation mode switch to DVD, the
joystick and –operations are changed for
DVD player.
TV mode operation
When operating a Pioneer TV tuner (e.g. GEX-
P5700TV(P) or GEX-P5750TV(P)) with this remote
control, operation mode switch is normally
switched to TV. If you switch the remote control
operation mode switch to TV, the joystick opera-
tion is changed for TV tuner.
Setting the remote control code
type
When the remote control operation mode switch
is set to DVD, changing the remote control code
type enables you to operate the Pioneer DVD
player with this remote control. There are three
remote codes, code type A, code type Band
code type AVH.
To operate a multi-DVD player
When operating a multi-DVD player (e.g.
XDV-P9II), select code A.
To operate a DVD navigation unit
When operating a DVD navigation unit,
select code B.
To operate an AV-Receiver
When operating an AV-Receiver (e.g. AVH-
P5700DVD), select code AVH.
1 Set the remote control code selection
switch on the left side of the remote control to
the appropriate position with a pen tip or other
pointed instrument.
•If you select AVH mode, there is no need to
take the following procedure.
•If you select A/B mode, take the following
procedure and change the code type to the
appropriate type.
2 Press and on the remote control simul-
taneously to change the code type.
Initially, the code type is set to A. Each time you
press and simultaneously on the remote
control the code type switches between Aand
B.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful inter-
ference, and (2) this device must accept any
interference received, including interference
that may cause undesired operation.
Information to User
Alteration or modifications carried out with-
out appropriate authorization may invalidate
the user's right to operate the equipment.
Before you startBefore you start
PIONEER CORPORATION
4-1, MEGURO 1-CHOME, MEGURO-KU, TOKYO 153-8654, JAPAN
PIONEER ELECTRONICS (USA) INC.
P.O. Box 1540, Long Beach, California 90801-1540, U.S.A.
TEL: (800) 421-1404
PIONEER EUROPE N.V.
Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium
TEL: (0) 3/570.05.11
PIONEER ELECTRONICS ASIACENTRE PTE. LTD.
253 Alexandra Road, #04-01, Singapore 159936
TEL: 65-6472-7555
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
178-184 Boundary Road, Braeside, Victoria 3195, Australia
TEL: (03) 9586-6300
PIONEER ELECTRONICS OF CANADA, INC.
300 Allstate Parkway, Markham, Ontario L3R OP2, Canada
TEL: 1-877-283-5901
PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.
Blvd.Manuel Arila Camacho 138 10 piso
Col.Lomas de Chapultepec, Mexico, D.F. 11000
TEL: 55-9178-4270
Published by Pioneer Corporation.
Copyright © 2004 by Pioneer Corporation.
All rights reserved.
Publication de Pioneer Corporation.
Copyright © 2004 Pioneer Corporation.
Tous droits de reproduction et de traduction
réservés.
Printed in Japan
Imprimé au Japon
<CZR5026-A> E<KSNZX> <05C00000>
Remote control for DVD-VIDEO
Télécommande pour DVD-VIDEO
Owner’s Manual
Mode d’emploi
CD-R5
Using the remote control
Point the remote control in the direction of the
front panel to operate.
•The remote control may not function properly
in direct sunlight.
Precaution
•Do not store the remote control in high tem-
peratures or direct sunlight.
•Do not let the remote control fall onto the floor,
where it may become jammed under the brake
or accelerator pedals.
Specifications
Power source ...................... 3 V DC
(Lithium Battery: CR2025)
Dimensions (W ×H ×D): .... 52 ×123 ×11 mm
Weight ................................. 50 g (including battery)
Infered Remote Control
<Wavelength> .................. 945 nm
<Output> .......................... typ; 10 mw/sr per infrared
LED
Note
•Specifications and the design are subject to
possible modification without notice due to
improvements.
