643482
32
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
DT2011659-00
6.13 START UP ANd NORMAL OPERATION
•Before proceeding with lighting the stove:
a Ensure that the hearth door is well closed.
a Never use gasoline, gasoline-type lantern fuel, kerosene,
charcoal lighter uid, or similar liquids to start or ”freschen
up” a re in this heater. Keep all such liquids well away from
the heater wihle it is in use.
a Warning against overring:
- Pellets must not be fed manually into the burn pot.
- Never add additional fuel by hand.
- Do not ll the hopper with any fuels other than wood pellet.
- Accumulated un-burnt pellets in the burn pot after a failed
ignition must be removed before starting a new ignition
process.
Description of activity Display
Keep key 4 pressed down for a few seconds.
A cycle starts with three phases which take the stove into the normal operating mode.
- CONTROL (rst 20 seconds).
The lighter (glow plug) activates.
12:30 CONTROL
START PHASE I
The extractor fan starts up.
The fuel-loading auger is activated and starts to feed pellets into the grate.
12:30 START
PHASE I
START PHASE II
- If the lighter has triggered the combustion process, the auger increases fuel loading
to allow a period of stabilisation and correct combustion of the pellets in the
subsequent normal operating mode.
- If during the startup phase the sensor on the ue gas outlet shows a rise in
temperature (sign that the combustion process is underway), the stove is considered
to be lit and goes into the normal operating mode.
12:40 START
PHASE II
Description of activity Display
If the readout NO LIGHTING appears on the display during the startup stage (and the
buzzer activates, if set), it means that the sensor installed on the ue gas outlet detects
no temperature rise (sign that the combustion process has not been triggered) or the
pellet hopper is empty. The stove goes into the alarm status.
12:30 NO LIGHTING
Shut down the stove by pressing key 4 for a few seconds: the warning buzzer stops.
The scrolling readout CLEANING GRATE appears on the display and when the stove has
cooled the readout OFF appears.
Check the causes of activation of the safety device and always remove all the fuel from
the grate before attempting ignition again.
12:30 CLEANING
GRATE
Restart the stove by pressing key 4.
Repeat the procedure given above for lighting the stove.
12:50 CONTROL
a If the stove occasionally fails to ignite it could be caused by:
- pellet composition or size not in compliance with the specications given in this booklet (see the “FUEL” section);
- insufcient mains voltage, whether in the form of intermittent voltage drops or a constantly lower value.
In the above cases any call-out of the service centre is not covered by the warranty, since the problem is not due to a defect in
the product.
STOVE STARTUP
DT2011660-00
IGNITION FAILURE
DT2011661-00
a Operate unit only with hopper lid closed.
Failure to do so may result in emmision of products of
combustion from the hopper under certain conditions.
a The mains plug is properly inserted into the socket.
•Check that the pellet tank is full or at least contains enough pellets for
the stove to run for the desired period.
H07029330 / DT2001081 – 02
32
English
32

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Piazzetta SABRINA bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Piazzetta SABRINA in de taal/talen: Engels als bijlage per email.

De handleiding is 2,92 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info