643476
23
Verklein
Vergroot
Pagina terug
1/64
Pagina verder
Power cable (6)
•The stove/rebox comes with a power cable which must be connected
to a 120V AC electrical outlet mains socket. Connection to the rear of
the stove/rebox is shown in g. 42.
•The power rating is indicated in the paragraph “TECHNICAL DATA”.
a The appliance must be connected to an efcient earthing/
grounding system.
a Any stove installed in a mobile home must be electrically
grounded to the steel chassis of the home and bolted to the
oor in Model compliance with, and according to building
code requirements.
a Ensure that in its normal position the power cable does not
come into contact with any heated parts.
a Ensure that the electrical plug is accessible also after
installation of the stove.
a In Canada, the electrical installation must meet the appliance
requirements for CSA C22.2
Room sensor connection (5)
•When installing the stove/rebox, it is necessary to connect the room
sensor (provided) to the correct jack (Fig. 40). The sensor can be
positioned as shown in g. 41, otherwise remove the band, uncoil the
lead and then place the sensor in a spot where a more accurate room
temperature reading can be obtained.
Pipe tap (3)
•The appliance has an external socket for measuring the pressure
(vacuum) of the ue gas outlet pipe. This control and verication should
be carried out by authorised personnel at the time of installation or
during maintenance.
Connection to the DB9 serial socket (7)
•The appliance has a DB9 serial socket, which is used to check
appliance operation. Controls should be carried out by authorised
personnel at the time of installation or during maintenance.
1
4
3
2
7
Fig. 40
1 External jack for connection of
room sensor
2 Socket for power lead
3 Pipe tap
4 Knockout for inserting cable gland
PG7 for connection of external
thermostat
6
5
Fig. 41 Fig. 42
5 Room sensor connection
6 Power lead connection
7 DB9 serial socket
DT2010146-00
5.2 ELECTRICAL CONNECTIONS ANd CONTROLS
The appliance is designed for connection to an external room thermostat
(not included in the package).
To connect the thermostat use a 2x0.5 mm
2
cable secured with a PG7
cable gland to be inserted in the relative hole in the rear panel (Fig. 40).
Only authorised personnel should carry out this operation.
a Installation can be carried out with any type of room thermostat
but requires a PG7 cable gland similar to that shown in g. 44.
To connect the room thermostat to the electronic board, refer
to the wiring diagram.
To install, proceed as follows:
- cut off the electricity to the appliance before opening it;
- remove the electronic board protective panel (Fig. 44);
- remove the knockout to be found in the rear panel (position 4 – gure
40);
- clamp the thermostat cable with the PG7 cable gland and insert the
gland into the hole in the rear panel (Fig. 45);
- connect the thermostat terminal to the 2-pin terminal of the electronic
board (see WIRING DIAGRAM);
- replace the electronic board protective panel.
DT2010147-03
5.3 INSTALLING ThE ExTERNAL ThERMOSTAT
1
2
3
4
Fig. 43
1 Thermostat
2 Electronic board 2-pin terminal
3 Cable gland PG 7
4 Thermostat cable terminal
ELECTRONIC BOARD
PROTECTIVE PANEL
Fig. 44 Fig. 45
H07028100/DT2000970 – 01
23
English
DT2030224-01
DT2030225-01 DT2030226-01
DT2030076-00
DT2030227-01 DT2030228-00
23

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Piazzetta-P960

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Piazzetta P960 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Piazzetta P960 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,34 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info