.......... ..........
10 Turning on Your VCR
• Before turning on your VCR, make sure there are batteries in
the remote control and the VCR, TV, and Cable Box/DBS (if
applicable) are connected.
• The menus will appear every time you turn on the VCR until
you complete the steps on pages 10-11.
• If you want to set up the Controller now, you must first con-
nect the Controller. See page 50 before continuing.
• Leave the Cable Box turned on if you plan to set up the Cable
Box Controller now.
• If you plan to set up the Controller now, set the Cable Box to a
channel other than channel 09.
• Read through these steps before you begin; the process will be
easier if you familiarize yourself with this information before
beginning.
1
Press the VCR button, then press the POWER button.
3
Press the PLAY 8 or STOP 9 button to select the lan-
guage of the on-screen displays and menus.
2
Turn on the TV.
4
Press the OK/STATUS button. The menu shown below will
appear.
➔ ENGLISH
ESPAÑOL
FRANÇAIS
SELECT: 89 CONFIRM: OK
END: MENU
CABLE BOX CONTROLLER
OFF
A OFF CH.=CHANNEL
ON CH. 2 ON CH. 7
ON CH. 3 ON CH. 8
ON CH. 4 ON CH. 9
ON CH. 5 ON A/V FRONT
ON CH. 6 ON A/V REAR
SELECT: ,9 CONFIRM:OK
END:MENU
• Auto or – – : – – may appear on
the display panel until the clock is
set.
• If you do not want to set up chan-
nels now, press the MENU button
at step 6. TUNER NOT SET will
appear on the screen briefly.
• You may not set up channels at
step 6 if you are using a Cable
Box/DBS.
Helpful Hints
3
4
1
2
Turn on the TV. Set it to channel 3 or 4, whichever chan-
nel the CH3/CH4 switch on the back of the VCR is set to
(or your Cable Box/DBS output channel, if applicable).
The menu shown below will appear.
