Using the appliance
Setting the timer (HB826 only)
1 Fully unwind the mains cord.
2 Insert the mains plug into the wall socket.
3 Consult the memory knobs and the table in these instructions for use.
4 Put on the protective goggles supplied.
5 Set the timer to the required tanning time (fig. 12).
6 Lie down under the lamp unit.
◗ Once the set time has elapsed, the timer will switch off the tanning appliance automatically.
B
NOTE: the timer can be set up to a maximum of 60 minutes. If you wish to treat both sides of
your body directly after each other, we advise you to reset the timer just before the set time has
elapsed. By doing this, you can avoid the 3-minute waiting period which would otherwise be
necessary before the lamps can be switched on again.
Remote control unit (HB828 only) (fig.1)
a Time setting button for 1-30 minutes.
b Start button: press this button to switch on the tanning lamps and the timer.
c Pause/repeat button: press this button if you want to interrupt the session(e.g. when the
telephone rings).The tanning lamps will go out and the remaining time of the session will blink in
the display.You can also press this button during the last minute of a session to repeat the set
time (e.g. to treat the other side of the body).
d Blinking signal: this signal is only visible when the timer is counting down the time.
e Pilot light: this light is on when the appliance is connected to the mains.
f Beeper: the beeper indicates that the last minute of the time set for the tanning session has
started.
- If you want the tanning appliance to operate longer than the set time, you will have to set a
new time when you hear the beeper go off.You can also press button T during the last
minute of a session to repeat the set time.
g Display: the display shows the set time. During the session the display shows the remaining time.
B
ATTENTION
In the following cases you will see 00 in the display:
- after you have inserted the plug into the wall socket;
- at the end of the tanning session (blinking during the first three minutes);
- after a mains failure;
- after the overheat protection has come into operation.
In these cases the tanning lamps will not be on.
1 Fully unwind the mains cord and take the remote control unit out of the storage
compartment (B).
2 Insert the mains plug into the wall socket.
3 Consult the memory knobs and the table in these instructions for use.
4 Put on the protective goggles supplied.
ENGLISH8
